FAQ AND TROUBLESHOOTING
How do I set the time only, if the ST9100S clock is not
correct?
Your ST9100S contains a very accurate digital clock that is factory pre-set. Should
you ever need to change the time, just follow this procedure:
a. Move the slider to the DAY/TIME position.
b. Keep pressing the green button until the message ‘SET THE TIME’ is
displayed. To change the time, press the or buttons until the correct
time is shown. The message ‘IS TIME OK?’ will be displayed. Press the green
button to confirm the time is correct. If you have made a change, the message
‘TIME SAVED’ will show, followed quickly by ‘DATE + TIME COMPLETE’.
c. Move the slider to the RUN position, to complete changing the time.
What do I do when the clocks go back in October and forward
in March?
Your ST9100S is factory-set to adjust the clock automatically at the correct dates,
so you should never need to adjust the clock forward or backwards yourself. It is
possible to disable this particular feature, as described in the section ‘Changing the
Installer Parameters’ (page 12). You may also check the section ‘Configuration &
Service Data’ (page 18) to see how your Installer has configured your product.
What should I do if I get ‘lost’ while programming the
ST9100S?
The LoT™ Display on ST9100S will provide you with help and tips to work through the
programming. Should you ever get ‘lost’, the simplest thing to do is to move the slider
to the RUN position, and then move it back to the appropriate programming position
where you got lost. At this point just follow the instructions again.
What happens if there is a power failure?
In the event of a mains power failure, the ST9100S display will go blank, the indicator
lamp will go out, and the control output will switch off. The real time will be constantly
maintained by means of the built-in battery backup, ready to power back up as if
nothing had happened when the mains power is restored. In addition, all programmes
and settings are stored in a special memory (called NV memory) which requires no
power to maintain information, and so will be retained indefinitely.
Should the correct time and date ever be lost, for whatever reason, the message ‘SET
DATE + TIME’ will be displayed whilst the slider is in the RUN position. In this case,
simply follow the procedure described under ‘Step 1: Setting the Date & Time’
(page 4). It should not be necessary to make any changes to your programmes.
