Manual Honeywell HFD360 Series - AIRGENIUS 6 (page 4 of 18) (English, French, Spanish)

723813

Zoom out

Zoom in

1/18

6 7

REMOVING THE IFD® PARTICLE FILTER

CAUTION: Power OFF the air cleaner, but leave the unit plugged in to electrical

outlet. Wait 60 seconds before removing the rear grille to check the filters.

When the ifD® Particle Filter is removed, the CHECK FILTERS light will illuminate

(it may already be on if you’ve been using your air purifier for a while). The CHECK

FILTERS light will shut off when the ifD® Particle Filter is returned to the unit (after

cleaning) and the Electronic Filter Timer will reset back to zero.

• Press down on the tab on the rear grille and pull the grille down and toward you

(Fig. 5). Remove the grille.

• With one hand, hold the air cleaner steady and use your other hand to grasp

ifD® Particle Filter and pull out (Fig. 6).

• To place the ifD® Particle Filter back into the air cleaner housing, insert it at the

bottom and ensure it is pushed in as far as it can go. Use one hand to support the

filter at the bottom while pressing the top of the filter into place. You will hear an

audible “click”.

• Return the grille to the air cleaner housing. You will hear an audible “click” when the

grille is installed correctly.

• The CHECK FILTERS light will remain illuminated if the

ifD® Particle Filter

is not properly

seated.

CLEANING THE IFD® PARTICLE FILTER

The ifD® Particle Filter should be cleaned every 3 months.

Turn the power off but DO NOT unplug the air cleaner. After removing the ifD® Particle Filter

from the air cleaner, follow the steps below to clean the ifD® Particle Filter.

• Rinse the filter with clean tap water (Fig. 7).

• If the filter still appears dirty, proceed to “Washing,” otherwise proceed to “Drying.”

Washing:

• Remove the ifD

Particle Filter from the unit.

• Fill a sink with lukewarm water and add a few drops of mild dish soap.

• Gently swish the filter in the soap solution to clean.

• Soak the filter for 23 minutes. DO NOT leave the filter in the water for more than 5 minutes.

• Rinse the filter with clean tap water (Fig. 7). Proceed to “Drying”.

Note that the filter may still be discolored even after washing.

This is normal staining that occurs and will not affect performance.

Drying:

• Shake the filter to remove any excess water.

• Place the filter with the honeycomb side down on a plush towel.

• Allow the ifD® Particle Filter to dry for a few hours or overnight.

• When the ifD® Particle Filter is completely dry, place it back into the air cleaner. The CHECK FILTERS light will

automatically shut off and the filter timer will be reset

CAUTION: NEVER place a wet ifD® Particle Filter in your air cleaner.

• The ifD® Particle Filter is NOT dishwasher safe. DO NOT place the ifD® Particle Filter in a dishwasher or subject

it to other extreme hot water conditions.

• DO NOT use any solvents, strong cleaning agents or flammable liquids to clean the ifD® Particle Filter.

Fig. 7

The AirGenius 6 uses the Odor & VOC Reducing

Pre-filter. The pre-filter helps

capture large airborne particles that enter the rear grille and also helps trap common

household odors and VOCs (gases).

This pre-filter is not washable and will lose its effectiveness over time. It should be

replaced every 3 months when you clean the ifD® Particle Filter for optimum odor and

VOC reduction performance.

To remove and replace the pre-filter, remove the rear grille and gently untuck the filter

from the plastic retention clips and dispose of used pre-filter. Remove the plastic bag

and place a fresh

pre-filter on the rear grille and tuck the edges under the plastic

clips to hold securely in place. Return the rear grille to the air cleaner.

REPLACING THE ODOR & VOC REDUCING PREFILTER

Odor & VOC

Reducing

Pre-filter

Rear

Grille

We recommend that you clean the air cleaner at least once every 3 months and before extended storage.

Unplug unit from outlet before cleaning. Use only a dry cloth to wipe the external surfaces of the air cleaner.

DO NOT USE WATER, WAX POLISH, OR ANY CHEMICAL SOLUTION.

CLEANING AND STORAGE

The ifD® Particle Filter is washable and does not need to be replaced. The Odor & VOC Reducing

Pre-filter

(Model HRFK2) is not washable and should be replaced every 3 months for optimal odor and VOC reduction

performance.

To ensure stated product performance, use only Genuine Honeywell Replacement filters.

You may purchase Honeywell replacement Odor & VOC Reducing

Pre-filters

from the retailer where you purchased your air cleaner or order directly from

www.replacementfilters.com

Odor & VOC Reducing

Pre-filter: Model HRFK2 (2 pack)

If you have any questions about the ifD® Particle Filter, call 18004770457 or

email consumerrelations@kaz.com.

REPLACEMENT FILTERS

Fig. 8

Fig. 6

Fig. 5

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Honeywell HFD360 Series - AIRGENIUS 6 in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 4,99 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Honeywell HFD360 Series - AIRGENIUS 6 Manual

Product: