686441
7
Zoom out
Zoom in
Previous page
1/9
Next page
USE & OPERATION (CONTINUED)
EN 6
CLEANING THE CARBON DUST FILTER* AND HONEYCOMB COOLING MEDIA
WARNING:
Before cleaning the unit, switch the unit OFF and disconnect the power adapter from the unit and
electrical socket.
Figure 1:
Honeycomb
Cooling Media
Rear Grill
Band
Holder
Honeycomb
Frame
Carefully remove the rear grill from the unit.
Remove the two band holders to release the carbon
dust filter*.
Rinse the filter with clean water and let it dry before
re-installing to the rear grill.
Pull out the Honeycomb Cooling Media. Slide down
and remove the Honeycomb Frame.
Replace or clean media with water and a damp cloth as
needed.
WARNING: DO NOT operate the Air Cooler when the
Rear Grill is removed from the Air Cooler, or if there is a
loose-fitting Rear Grill. Doing so can cause serious
injury or dangerous electrical shock.
1.
2.
3.
4.
5.
Removing the Carbon Dust Filter*/ Honeycomb Cooling Media:
*Applicable for models with Carbon Dust Filter only.
The appliance is supplied with a Carbon Dust Filter*
and Honeycomb Cooling Media.
The Carbon Dust Filter* and Honeycomb Cooling
Media are located inside the Rear Grill. See Figure 1
for instructions on how to remove them from the
unit for cleaning and maintenance.
Do not run the unit in COOL mode with stale water
in the tank. You must empty the water tank
and refill with fresh water, especially if the tank has
not been cleaned in a long time.
The cleaning frequency for the Honeycomb media
depends on local air and water conditions. In areas
where the mineral content of water is high, mineral
deposits may build up on the Honeycomb Cooling
Media and restrict air flow. Draining the water tank
and refilling with fresh water at least once a week
will help reduce mineral deposits. If mineral
deposits remain on the Honeycomb Cooling Media,
the media should be removed and washed under
fresh water. The media should be cleaned every two
months or sooner, depending on your needs.
For best results allow the Honeycomb Cooling
Media to dry after each use by turning off the cool
function 15 minutes before turning the unit off.
Carbon Dust
Filter*
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Honeywell ES800 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Honeywell ES800 in the language / languages: English as an attachment in your email.

The manual is 2,66 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info