32377
22
Zoom out
Zoom in
Previous page
1/24
Next page
22
FREQUENTLY ASKED QUESTIONS 69-0654-5
Frequently asked questions
If... Then...
Display will not come on Make sure the batteries are fresh and installed correctly.
Set the System switch to OFF. Remove the batteries and then insert them
backwards for five to ten seconds to reset the thermostat. Replace the
batteries correctly. The display should come on.
Temperature display will not go
lower than 45°F (7°C) or higher
than 88°F (31°C) during
programming
You have reached the temperature limit. The setting range is 45°F–88°F
(7°C–31°C).
Display shows flashing or steady
“bAt Lo”
The batteries are low; replace them as soon as possible. See page 18 for
instructions.
If “bAt Lo” continues to display after replacing the batteries, set the System
switch to OFF and insert the batteries backwards for five to ten seconds.
Then replace the batteries correctly. The display should come on.
Temperature change occurs at the
wrong times
Check the
ro
ram times for the
eriod in
uestion. Be sure that
AM
and
PM
indications are correct. Make sure the current da
and time are correct.
Re
ro
ram if necessar
.
Heating will not come on Check that the System switch is set to HEAT.
Check the system fuse or circuit breaker and replace or reset if necessary.
Check for correct wiring and good connections.
If display is blank or displays “bAt Lo,” install fresh batteries.
Allow time for the furnace to heat up and the fan to come on before checking
for heat at the register.
If the temperature setting is higher than the current room temperature and
the SYSTEM ON arrow is displayed, the thermostat is operating correctly.
Contact a heating contractor for assistance.
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Honeywell CT3300 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Honeywell CT3300 in the language / languages: English as an attachment in your email.

The manual is 0,42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info