474024

Honeywell Chronotherm III - 69-0690 Manual

18
Zoom out
Zoom in
Previous page
1/30
Next page
SELECTING RECOVERY SETTING
29
30
Your T8631A Thermostat includes a screw on the back
marked 2A, allowing for the Adaptive Intelligent Recov-
ery™/Conventional Recovery choice.
Your thermostat was shipped from the factory with the
screw positioned for Adaptive Intelligent Recovery
setting. Your installer may have left the screw in this
position, or may have changed it to Conventional
Recovery. Before programming, you must know which
recovery method your thermostat has been set for.
• With the Adaptive Intelligent Recovery setting, the
dwelling will reach the comfort temperature at the
exact time you have programmed into the thermo-
stat.
• With Conventional Recovery, the programmed time
will be the time your furnace comes on to start
recovery; therefore, you should program the start
time to be earlier than the desired comfort time. It
may require some trial and error for you to arrive at
the best starting time, and the best starting time will
vary as the seasons change.
SYSTEM
GRAVITY
AIR/WATER
HOT
WATER
GAS/OIL
WARM AIR
ELECTRIC
WARM AIR
1A
OUT
1 TURN
OUT
1 TURN
OUT
1 TURN
OUT
1 TURN
1B
IN
IN
(FACTORY SETTING)
IN
IN
M3064
1A
1B
2A
2B
DISPLAY TEMPERATURE
2B
o
C
F
o
OUT
IN
2B
2A
OUT
IN
2A
RECOVERY OPTION
ADAPTIVE
CONVENTIONAL
HEAT
CYCLE RATE
To determine which type of recovery is
set into your T8631A Thermostat,
make sure your thermostat is mounted
and powered on the wall.
Press key. Check thermostat display.
• If the ■■ shows in the lower right-
hand corner (see illustration), the
thermostat is set for Conventional
Recovery. If you would rather have
the Adaptive Intelligent Recovery
setting, remove thermostat from
wall, turn screw 2A (on back of
thermostat) clockwise until it
bottoms. DO NOT OVERTIGHTEN.
• If the ■■ does not show, the
thermostat is set for Adaptive
Intelligent Recovery™. If you would
rather have Conventional Recov-
ery, remove thermostat from wall,
turn screw 2A (on back of thermo-
stat) out 1/2 to 1 turn.
MON
WAKE
AM
M5058
INDICATES
THERMOSTAT IS SET FOR
CONVENTIONAL RECOVERY
RUN
PROGRAM
… 18 …


Need help? Post your question in this forum.

Forumrules
1

Forum

honeywell-chronotherm-iii---69-0690

Reset search

  • the Thermastat iss completely dark and furnace not working
    Submitted on 8-2-2020 at 15:43

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Honeywell Chronotherm III - 69-0690 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Honeywell Chronotherm III - 69-0690 in the language / languages: English as an attachment in your email.

The manual is 0,66 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info