Manual Honeywell BH-999E (page 5 of 82) (English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish)

460222

Zoom out

Zoom in

1/82

ENGLISH

IMPORTANT SAFETY INSTRUCTIONS

Read through all the instructions before starting to use the

fan heater. Keep this instruction manual in a safe place for

future reference.

1. Supervision is necessary when the fan heater is used in

the vicinity of children.

2. Do not use the fan heater outdoors.

3. The fan heater must only be used after it has been moun-

ted according to this instruction manual. Mount the fan hea-

ter vertically on a straight wall: Be sure to observe the speci-

fied safety distances as shown in Fig. 1 and 2, and also

observe your local safety regulations. Do not mount the fan

heater on combustible or instable surfaces (e.g. wood or

plastic surfaces) or under the ceiling. Fire hazard!

4. Unwind the power cord completely. An incompletely

unwound power cord can lead to overheating and cause a

fire. Do not touch the power cord with wet hands. Make

sure that there are no objects are resting on the power

cord or could come into contact with hot parts. Position

the power cord where nobody can trip over it and where

the power socket is easily accessible.

5. Do not use an extension cord, a multiway connector or

an infinitely variable speed controller. These can lead to

overheating, fire or electric shock.

6. Connect the fan heater only to a single-phase socket

with the supply voltage as stated on the type plate of the

appliance. The fan heater is equipped with double electric

insulation (Class II) and does not have to be earthed.*

7. Always switch the fan heater off with the rotary thermo-

stat switch (2) and always disconnect the power plug (8)

from the power socket when the fan heater is not in use.

Allow the fan heater to cool off for at least 20 minutes

before it is moved, handled or cleaned. Do not tug at the

power cord to disconnect the plug. Handle the fan heater

only with dry hands. Do not leave the fan heater unatten-

ded when it is running.*

8. Do not use the fan heater anywhere near inflammable

gases or substances such as solvents, lacquers, glues etc.

9. Do not mount the fan heater immediately under a power

socket.

10. Do not mount and use the fan heater in close proxi-

mity to a bathtub, a shower or a swimming-pool (Fig. 1).

11. Do not use the fan heater in any kind of vehicle (e.g.

portacabin, lift, elevator, motor vehicle, cubicle) or similar

enclosed space.

12. Caution: The air outlet vent (7) of the fan heater gets

very hot during use. Inflammable materials such as cus-

hions, pillows, duvets, blankets, furniture, paper, curtains,

drapes and clothing must be kept at least 100 cm distance

from the fan heater (Fig. 2).

13. Keep the fan heater clean. Make sure that the air intake

vent (6) and air outlet vent (7) are open before starting to

use the fan heater. Do not allow objects to get into the air

intake vent (6) or air outlet vent (7). Do not cover up the

fan heater (( ) symbol on the side of the fan heater) This

can lead to overheating, fire or electric shock.

14. Do not dip the fan heater in water or any other liquids

and do not pour water or any other liquids over the appli-

ance or into the air intake vent (6) or air outlet vent (7).

15. The fan heater is equipped with protection against

water, Grade IPX4. This facilitates use in a bathroom or a

damp environment. However, installation inside a bath or

shower cell is not possible. The safety distances shown in

Fig. 1 must be strictly observed. The rotary switch must

not be accessible to persons using the bathtub or shower.

16. Clean the fan heater regularly by following the cleaning

instructions.

17. The fan heater must only be used according to the

instructions in this instruction manual. Non-observance of

these instructions can result in injuries, fire, electric shock

or defects in the appliance.

18. The fan heater is intended exclusively for private use

indoors. It is not suitable for commercial use.

19. If the power cable of the fan heater is damaged it must

be replaced by the manufacturer or by a repair shop

approved by the manufacturer, or by similarly qualified

persons, so as to avoid damage.

20. Do not use this fan heater if it is damaged or shows

signs of damage, or if it has fallen down or is not functioning

correctly. Disconnect the power plug from the power socket.

CONSTRUCTION

Power control lamp

2. Rotary thermostat switch

3. Room temperature approx. + 5 °C ( )

4. Room temperature approx. + 30 °C

5. 60 minute timer

6. Air intake vent

7. Air outlet vent

8. Power cord with power plug*

9. Wall bracket indents

10. Rear wall bracket

11. Air filter

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Honeywell BH-999E in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 1,4 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Honeywell BH-999E Manual

Product: