625281

Honda WMP20XE Manual

14
Zoom out
Zoom in
Previous page
1/96
Next page
14
ENGLISH
Draining the Fuel Tank and Carburetor
1. Make sure the fuel valve is OFF.
2. Remove the carburetor drain screw with a 10 mm wrench or
screwdriver, and drain the fuel into an approved petrol container.
3. Turn the fuel valve [1] to the ON position. This will allow fuel in the
fuel tank to drain through the carburetor bowl.
4. Reinstall the drain screw [2] and gasket [3].
Engine Oil
Change the engine oil (page 8).
Engine Cylinder
1. Remove the spark plug (page 10).
2. Pour 5 ~ 10 cc of clean engine oil into the cylinder.
3. Slowly pull the starter grip a few times to distribute the oil in the
cylinder.
4. Reinstall the spark plug.
5. Pull the starter grip slowly
until resistance is felt.
Continue pulling slowly
until the arrow notch [1] on
the starter pulley aligns
with the hole [2] on the
recoil starter. Return the
starter grip gently. This will
close the valves so
moisture cannot enter the
engine cylinder.
PLACING IN STORAGE
If your pump will be stored with petrol in the fuel tank and carburetor, it
is important to reduce the hazard of petrol vapor ignition. Select a
well-ventilated storage area away from any appliance that operates
with a flame, such as a furnace, water heater, or clothes dryer. Also
avoid any area with a spark producing electric motor, or where power
tools are operated.
If possible, avoid storage areas with high humidity, because that
promotes rust and corrosion.
Unless all fuel has been drained from the fuel tank, leave the fuel
valve in the OFF position to reduce the possibility of fuel leakage.
Place the pump on a level surface. Tilting can cause fuel or oil
leakage.
With the engine and exhaust system cool, cover the pump to keep out
dust. A hot engine and exhaust system can ignite or melt some
materials.
Do not use sheet plastic as a dust cover. A nonporous cover will trap
moisture around the pump, promoting rust and corrosion.
REMOVAL FROM STORAGE
Check your pump as described in BEFORE OPERATION (page 4).
If the fuel was drained during storage preparation, fill the tank with
fresh petrol. If you keep a container of petrol for refueling, be sure that
it contains only fresh petrol. Petrol oxidizes and deteriorates over
time, causing hard starting.
If the cylinder was coated with oil during storage preparation, the
engine may smoke briefly at startup. This is normal.
B WARNING
Petrol is highly flammable and explosive.
You can be burned or seriously injured when handling
fuel.
• Stop the engine and keep heat, sparks, and flame
away.
• Handle fuel only outdoors.
• Wipe up spills immediately.
[1]
ON
[2]
[3]
[2]
[1]
WMP20XE.book Page 14 Thursday, August 28, 2008 2:43 PM
… 14 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Honda WMP20XE at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Honda WMP20XE in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 10,65 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info