478015
12
Zoom out
Zoom in
Previous page
1/18
Next page
12 EN
TRANSPORT AND STORAGE
TRANSPORT
When transporting or carrying your brush
cutter, the engine must always be stopped
and the transport guard must be installed on the cutting
attachment.
When carrying your brush
cutter, hold it by the
transmission tube in a
balanced position. If it is to be
transported in a vehicle, make
sure that it is properly secured
so it cannot move. It must be
positioned so that there is no
risk of fuel leakage.
STORAGE
If the machine is not to be used for more than two months, the
following storage precautions should be taken:
- Drain the fuel tank and run the engine to empty the carburettor.
- Remove the spark plug and pour a few drops of oil (same quality
as that used in the engine) into the cylinder.
- Gently pull the recoil starter to distribute the oil in the cylinder and
on the piston. Then reinstall the spark plug.
- Clean the whole machine, paying special attention to plant
residues accumulated around the cutting attachment, in the
engine cooling fins and under the cowlings.
- Using a paint brush, apply a thin film of standard oil over the metal
cutting attachments to prevent corrosion.
- Store the machine in its packaging, in a cool dry place.
- If the machine is to be stored in a vertical position, place it with the
engine at the bottom so that it will not topple over.
FOLDING THE HANDLE (TYPE UEET ONLY)
For easier storage, the handle on your brushcutter can be swivelled
round. Proceed as described below.
CAUTION:
Turn the handle the clockwise only.
Never swivel the handle through more than a quarter of a turn.
Do not unscrew the knob [1] by more than 6 turns.
USING THE AFTER A STORAGE PERIOD
1. Remove the spark plug, check that it is clean and that the
electrode gap is correct. Pull the starter several times.
2. We recommend that the spark plug be screwed down as far as
possible by hand until finger tight ; then use a plug spanner to
tighten it by an extra 1/8 or 1/4 turn.
3. Check the level and condition of the engine oil.
4. Fill the fuel tank and start the engine.
NOTE:
If the cylinder has been coated with oil, the engine will
smoke on start-up. This is normal.
FUEL STORAGE
NOTE:
Ensure that you use containers or drums
specifically designed for hydrocarbons [2].
This will prevent polluting the fuel through the
dissolution of the container walls, which will
lead to poor functioning of the engine.
The warranty does not cover a blocked
carburetor or valves jammed by old or polluted
fuel.
The quality of unleaded petrol alters very quickly (2 to 3 weeks in
some cases). Do not use fuel more than 1 month old. Store the
absolute minimum required for your monthly consumption.
ACCESSORIES
CURRENT PARTS, CONSUMABLES
Various accessories are supplied with the machine or are available
as options, depending on the model.
For your safety, it is strictly prohibited to
install any other attachment than the ones
listed above and especially designed for
your brushcutter's model and type.
SAFETY
D8 D10
D1 D4
1
2
3
[1]
UMK425E1 UMK435E1
LEET UEET LEET UEET
Mowing and clearing:
72560-VL6-P31
Standard
Thorny hedges and brush:
72511-VL6-P31 (Ø 255)
Standard
Large areas of grass:
72511-VF9-E32 (Ø 230)
72512-VL6-P31 (Ø 255)
Optional
Knotty brush and bushes (optional for types UMK435E1 UEET)
- 72511-VL6-H31
(Ø 200)
Prohibited Optional
Current parts
17211-Z0H-000
17211-Z0Z-000
Air filter
31915-Z0H-003
Spark plug
28462-ZM3-003
Recoil starter
Consumables
08221-888-010MP
Engine oil
[2]
[1]
[2]
[3]
[4]
SAFETY
C4 D3
A2
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Honda UMK435E at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Honda UMK435E in the language / languages: English as an attachment in your email.

The manual is 1,39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Honda UMK435E

Honda UMK435E User Manual - English, German - 88 pages

Honda UMK435E User Manual - German - 18 pages

Honda UMK435E User Manual - Dutch - 88 pages

Honda UMK435E User Manual - Dutch - 18 pages

Honda UMK435E User Manual - French, Italian, Spanish - 88 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info