625352
29
Zoom out
Zoom in
Previous page
1/42
Next page
29
MONTAGE
8. Glisser une pagaie [5] entre le fond du bateau et le sol pour maintenir le plancher [6] à plat.
9. T25 AE2
: Placer un longeron court [9] centré sur les planches n° 2 et n° 3.
T30 AE2 : Placer un longeron [9] centré sur la planche n° 3.
T35 AE2 et T40 AE2 : Placer un longeron court [7] avec un long [8].
10. Placer la pagaie de l’autre côté du bateau et répèter l’étape 9.
T35 AE2 et T40 AE2
: Mettre en place les deux autres longerons en prenant soin d'inverser
l'ordre comme indiqué ([7] court et [8] long).
11. Mettre le banc [10] en place.
PRÉCAUTION:
Ne pas gonfler les chambres entièrement en une seule fois.
En cas d’utilisation en altitude : si le bateau a été initialement gonflé au niveau de la mer puis
monté en altitude (lac de montagne), la pression intérieure des chambres a augmenté.
Ajuster la pression avant de naviguer.
12. Finir de gonfler les chambres en plusieurs fois, de manière à ne pas déséquilibrer les
pressions des différentes chambres (pression recommandée : 0,25 bar).
13. Vérifier la pression de gonflage à l’aide du manomètre livré avec votre bateau.
14. Gonfler la quille [11] (pression recommandée : 0,35 bar).
15. Refermer les valves avec leur capuchon afin de garantir une étanchéité maximum.
16. Fixer les pagaies [12] sur les dames de nage [13].
ASSEMBLY
8. Slide the oar [5] between the bottom of the boat and the ground to hold the deck [6] flat.
9. T25 AE2: Place a short stringer [9] centred on floor elements no. 2 and no. 3.
T30 AE2
: Place a stringer [9] centred on floor element no. 3.
T35 AE2 and T40 AE2: Place a short stringer [7] with a long stringer [8].
10. Place the oar on the other side of the boat and repeat step 9.
T35 AE2 and T40 AE2
: place the two other stringers being careful to reverse the order as
shown ([7] short and [8] long).
11. Fit the bench [10] into place.
CAUTION:
Do not fully inflate the chambers in one single operation.
In case of use at high altitude: if the boat was initially inflated at sea level, then transported
to a higher altitude (mountain lake, for example), the pressure inside the chambers will have
increased. Adjust the pressure before boating.
Check the inflation pressure using the pressure gauge supplied with your boat prior to each
use.
Check tightness of valve regularly with the tool provided
.
12. Finish inflating the chambers in several stages so as not to have the pressure in the various
chambers out of balance (recommended pressure: 0.25 bar).
13. Check the inflation pressure using the pressure gauge supplied with your boat.
14. Inflate the keel [11] (recommended pressure: 0.35 bar).
15. Close the valves by fitting their caps in order to ensure optimal airtightness.
16. Secure the oars [12] on the oarlocks [13].
om_T40_2006_D-GB-F.book Page 29 Jeudi, 16. octobre 2008 1:20 13
29


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Honda T27 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Honda T27 in the language / languages: English, German, French as an attachment in your email.

The manual is 2,92 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Honda T27

Honda T27 User Manual - Dutch, Italian, Spanish - 42 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info