625350
21
Zoom out
Zoom in
Previous page
1/42
Next page
21
MONTAGE
Ne pas utiliser de source à air comprimé (ex : compresseur) pour gonfler le bateau. Un
surgonflage peut entraîner la rupture des coutures et/ou des parois.
PRÉCAUTION:
Prendre soin de nettoyer la surface de montage et d’éliminer tout objet coupant ou pointu.
En cas d’utilisation en altitude : si le bateau a été initialement gonflé au niveau de la mer puis
monté en altitude (lac de montagne), la pression intérieure des chambres a augmenté.
Ajuster la pression avant de naviguer.
Vérifier la pression de gonflage à l'aide du manomètre livré avec votre bateau avant chaque
utilisation.
Vérifier régulièrement l'étanchéité des valves au moyen de l'outil fourni.
MODÈLES T20 SE2, T25 SE2 (planchers lattés) :
1. Déplier le bateau sur une surface plane et propre.
2. Vérifier que les valves [1] soient bien en place. Vérifier qu’elles aient toutes leur
capuchon [2] retenus par une garcette [3].
3. Première utilisation :
à l’aide du gonfleur à pied fourni avec votre bateau, gonfler les flotteurs
entièrement, en prenant soin de maintenir une pression équilibrée entre les différentes
chambres. Une fois gonflé entièrement, dégonfler les chambres à moitié en appuyant sur le
poussoir jaune [4] situé au centre de chaque valve.
Utilisations suivantes : à l’aide du gonfleur à pied fourni avec votre bateau, gonfler les
chambres à moitié de leur capacité.
4. Monter le banc [5].
ASSEMBLY
Do not use a compressed air source (ex.: air compressor) to inflate the boat.
Overinflation may cause the seams and/or walls themselves to rupture.
CAUTION:
Carefully clean the assembly area floor or surface and remove all sharp or pointed objects.
In case of use at high altitude: if the boat was initially inflated at sea level, then transported
to a higher altitude (mountain lake, for example), the pressure inside the chambers will have
increased. Adjust the pressure before boating.
Check the inflation pressure using the pressure gauge supplied with your boat prior to each
use.
Check tightness of valve regularly with the tool provided
.
MODELS T20 SE2, T25 SE2 (slatted flooring):
1. Unfold the boat on a flat, clean surface.
2. Check that the valves [1] are in place. Check that they all have their cap [2] held by a
retainer [3].
3. First use
: using the foot pump supplied with your boat, inflate the tubes completely, being
careful to balance the pressure between the various chambers. Once fully inflated, deflate
the chambers half way by pressing the yellow push-button [4] at the centre of each valve.
Subsequent uses:
using the foot pump supplied with your boat, inflate the chambers to half
their capacity.
4. Install the bench [5].
om_T40_2006_D-GB-F.book Page 21 Jeudi, 16. octobre 2008 1:20 13
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Honda T24 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Honda T24 in the language / languages: English, German, French as an attachment in your email.

The manual is 2,92 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Honda T24

Honda T24 User Manual - Dutch, Italian, Spanish - 42 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info