552645
737
Zoom out
Zoom in
Previous page
1/773
Next page
22-14
dummyheaddummyhead
LIGHTS/METERS/SWITCHES
4. ECM Serial Line Output Voltage Inspection
Turn the ignition switch OFF.
Disconnect the combination meter 16P (Gray)
connector.
Connect the ECM/PCM 33P connector.
Remove the maintenance lid (page 21-6).
Remove the DLC [1] from the battery box.
Short the DLC terminals using a special tool.
Rotate and hold the throttle grip [1] to the fully open
position.
Turn the ignition switch ON while holding the throttle
grip at the fully open position over 10 seconds.
The ECM/PCM enters the communication
diagnostic mode.
Measure the voltage at the combination meter 16P
(Gray) connector [1] of the wire harness side and
ground.
Does the standard voltage exist?
YES Inspect the combination meter (page 22-
10).
NO Replace the ECM/PCM with a known good
one, and recheck.
COMBINATION METER DIGITAL
CLOCK SET PROCEDURE
Turn the ignition switch ON.
Push and hold both the combination meter A button [1]
and B button [2] until the minute digits [3] indicate "1",
"2" or "3".
The combination meter enter the back light setting
mode.
Connection: Brown – Green
TOOL:
SCS connector [2] 070PZ-ZY30100
[1] [2]
[1]
Connection: Red/blue (+) – Ground (–)
Standard: 8 V or more (Every 5 seconds)
[1]
R/Bu
[2][1] [3]
737


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Honda NC 700 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Honda NC 700 in the language / languages: English as an attachment in your email.

The manual is 19,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info