580898
18
Zoom out
Zoom in
Previous page
1/23
Next page
18
ENGLISH
Loading and Unloading
Position the mower so all four wheels are on the bed of the transport
vehicle. Tie the mower down with rope or straps, and block the
wheels. Keep the tie-down rope or straps away from the controls,
adjustment levers, cables, and the carburetor.
NOTICE
To prevent losing control of or damaging the mower, do not use the
drive system when going up or down a loading ramp.
To prevent damaging the drive system, do not engage the clutch
when the mower is rolling backwards.
1. Turn the fuel valve to the OFF position.
2. Use a suitable loading ramp.
Adjust the loading ramp so
that it is inclined at an angle of
less than 15°. If a loading
ramp is not available, two
people should lift the mower
on and off the transport vehicle while keeping the mower level.
STORAGE
Proper storage is essential for keeping your lawn mower troublefree
and looking good. The following steps will help protect the mower
from rust and corrosion, and make the engine easier to start when you
use the lawn mower again.
Cleaning
1. Wash the lawn mower, including the underside of the mower deck.
Engine
Wash the engine by hand, and be careful to prevent water from
entering the air cleaner.
NOTICE
Using a garden hose or pressure washing equipment can force
water into the air cleaner. Water in the air cleaner will soak the
filters and can enter the carburetor or engine cylinder, causing
damage.
Water contacting a hot engine can cause damage. If the engine
has been running, allow it to cool for at least a half hour before
washing.
Mower Deck
If using a garden hose or pressure washing equipment to clean the
mower deck, be careful to avoid getting water into controls and
cables, or anywhere near the engine air cleaner or muffler
opening.
Before washing the underside of the mower deck, be sure the
throttle lever is in the STOP position and the fuel valve is in the
OFF position. Tilt the mower to the right so the fuel cap is up. This
will help to prevent fuel leakage and hard starting due to carburetor
flooding. Wear heavy gloves to protect your hands from the
blade(s).
Grass Bag
Remove the bag from the mower, and wash it with a garden hose
or pressure washing equipment. Allow the bag to dry completely
before storage.
2. After washing the lawn mower, wipe dry all accessible surfaces.
3. With the mower in an upright position, start the engine outdoors,
and let it run until it reaches normal operating temperature to
evaporate any water remaining on the engine.
4. Stop the engine and allow it to cool.
5. After the lawn mower is clean and dry, touch up any damaged
paint, and coat other areas that may rust with a light film of oil.
Charging the Battery (HZEA type)
To assure maximum reliability, the battery should be recharged (boost
charged) both before and after prolonged storage (see page 16).
Petrol
NOTICE
Depending on the region where you operate your equipment, fuel
formulations may deteriorate and oxidize rapidly. Fuel deterioration
and oxidation can occur in as little as 30 days and may cause damage
to the carburetor and/or fuel system. Please check with your servicing
dealer for local storage recommendations.
Petrol will oxidize and deteriorate in storage. Old petrol will cause
hard starting, and it leaves gum deposits that clog the fuel system. If
the petrol in your mower deteriorates during storage, you may need to
have the carburetor and other fuel system components serviced or
replaced.
The length of time that petrol can be left in your fuel tank and
carburetor without causing functional problems will vary with such
factors as blend, your storage temperatures, and whether the fuel
tank is partially or completely filled. The air in a partially filled fuel tank
promotes fuel deterioration. Very warm storage temperatures
accelerate fuel deterioration. Fuel deterioration problems may occur
within a few months, or even less if the petrol was not fresh when you
filled the fuel tank.
To prevent fuel related problems:
1. Add petrol stabilizer following the manufacturer’s instructions.
When adding a petrol stabilizer, fill the fuel tank with fresh petrol. If
only partially filled, air in the tank will promote fuel deterioration
during storage.
2. After adding a petrol stabilizer, run the engine outdoors for
10 minutes to be sure that treated petrol has replaced the
untreated petrol in the fuel system.
3. Turn the fuel valve to the OFF position.
4. Continue to run the engine until it stops
from the lack of fuel in the carburetor
fuel bowl. Running time should be less
than 3 minutes.
The warranty does not cover fuel
system damage or engine
performance problems resulting from
neglected storage preparation.
Engine Oil
Change the engine oil (page 13).
Engine Cylinder
If the mower is to be stored for more than
3 months, remove the spark plug
(page 14). Pour 5 ~ 10 cm³ of clean
engine oil into the cylinder [1]. Pull the
starter rope several times to distribute
the oil in the cylinder. Reinstall the spark
plug.
Pull the starter rope slowly until
resistance is felt, then return the starter
grip gently. This will close the valves so moisture cannot enter the
engine cylinder.
15°
OFF
[1]
HYEHZE bk1.book Page 18 Monday, September 8, 2008 9:46 AM
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Honda HRX537 HYEA at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Honda HRX537 HYEA in the language / languages: English as an attachment in your email.

The manual is 2,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Honda HRX537 HYEA

Honda HRX537 HYEA User Manual - English, German - 128 pages

Honda HRX537 HYEA User Manual - German - 24 pages

Honda HRX537 HYEA User Manual - Dutch - 128 pages

Honda HRX537 HYEA User Manual - Dutch - 88 pages

Honda HRX537 HYEA User Manual - French, Italian, Spanish - 128 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info