580909
12
Zoom out
Zoom in
Previous page
1/22
Next page
12
ENGLISH
Dry Grass
If the ground is too dry, mowing will stir up a lot of dust. Besides being
unpleasant to work in, too much dust will clog the carburetor air filter.
If dust is a problem, water your lawn the day before mowing. Mow
when the grass is dry to your touch, but the soil is still moist.
Wet Grass
Wet grass is slippery and can make you lose your footing. Also, wet
grass clippings will clog the mower deck and collect in clumps on the
lawn. Always wait for wet grass to dry before mowing.
Fallen Leaves
Your mower can be used to pick up fallen leaves for disposal. If using
the mower to bag large amounts of fallen leaves, and not for mowing,
set the cutting height adjustment levers so the front of the mower
deck is one or two settings higher than the rear. To start, position the
Clip Director knob in the #9 position (not quite full mulching). This
setting will allow the leaves to be recirculated and recut until the
particles are small enough to pass though the sliding door opening
and into the grass bag. Depending on the size, type, and water
content of the leaves, it may be necessary to open the sliding door to
allow for best bagging results. Using the sliding door correctly will
allow better grass bag filling, resulting in less grass bag emptying. Be
sure there are no obstacles, including rocks, hidden under the leaves.
If you want to mulch fallen leaves into your lawn, don't let the leaf
cover get too deep before you begin. For best results, start mulching
while grass still shows through the leaf cover. Position the Clip
Director knob in the MULCH position. In places where fallen leaves
completely cover the grass, remove the leaves by raking, or use the
grass bag so your mower can pick them up for disposal.
Clogged Mower Deck
Before clearing a clogged mower deck, stop the engine and turn the
fuel valve to the OFF position. With the spark plug cap disconnected,
tilt the mower so the air cleaner side is up.
Clear a clogged deck with a stick, not your hands.
Mowing Patterns
Your Honda mower will work most efficiently if you use the following
mowing patterns as much as possible. Mower deck and equipment
design, and the direction in which the blades rotate, cause these
mowing patterns to give the best results.
Mulching
Use a counterclockwise mowing
pattern when the Clip Director
knob is in the full MULCH
position. If the lawn has an
irregular shape, or many
obstacles, divide it into sections
where you can use
counterclockwise mowing
patterns.
Bagging
Use a clockwise mowing pattern.
This will give the best Clip
Director and bagging
performance, leaving the least
amount of clippings on the lawn.
Rear Discharge Mowing
Remove the grass bag and close
the discharge guard. Adjust the
Clip Director knob to the desired
setting and begin mowing in a
clockwise mowing pattern. If the
lawn has an irregular shape, or
many obstacles, divide it into
sections.
TRANSPORTING/STORAGE
TRANSPORTING
Before Loading
If the engine has been running, allow it to cool for at least 15 minutes
before loading the mower on the transport vehicle. A hot engine and
exhaust system can burn you and can ignite some materials.
Turn the fuel valve to the OFF position. This will prevent carburetor
flooding and reduce the possibility of fuel leakage.
Handlebar Folding
1. Remove the grass bag, if
so equipped. You can
place it on top of the
engine, with the bag
opening to the front.
2. Loosen the lower
handlebar locking knobs
[1].
3. Spread the lower ends of
the handlebar struts [2]
to release the locating
pins. Fold handlebar
over mower.
When folding the handlebar, be careful to avoid kinking or pinching
the control cables.
Loading and Unloading
Position the mower so all four wheels are on the bed of the transport
vehicle. Tie the mower down with rope or straps, and block the
wheels. Keep the tie-down rope or straps away from the controls,
adjustment levers, cables, and the carburetor.
MULCHING PATTERN
BAGGING & REAR-DISCHARGE
PATTERN
OFF
[1]
[2]
HXE.book Page 12 Monday, August 6, 2007 10:44 AM
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Honda HRX537 HMEA at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Honda HRX537 HMEA in the language / languages: English as an attachment in your email.

The manual is 4,92 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info