580909
8
Zoom out
Zoom in
Previous page
1/22
Next page
8
ENGLISH
Cutting Height
Check the mower deck cutting
height settings, and be sure that
all four adjustment levers [1] are
set to the same cutting height
position.
To adjust cutting height, pull
each adjustment lever [1] toward
the wheel, and move it into another
notch.
If you are not sure what cutting
height to select, start with a high
setting and check the appearance
of the lawn after mowing a small
area. Then readjust cutting height if necessary.
Rear Shield
During normal use the rear shield is subject to deterioration and wear.
Remove the grass bag and raise the discharge guard to check the
rear shield for cracks or tears. If the rear shield is excessively worn,
have it replaced by your authorized Honda servicing dealer.
Clip Direction
Clip Director Knob Adjustment
Adjust the Clip Director knob [1] in any one of the ten positions to
achieve the desired mowing results.
To adjust the Clip Director knob, pull the knob downward and towards
the rear of the mower. The knob adjusts a sliding door [2] from the
fully open BAG position to the fully closed MULCH position (see the
following page).
If a high resistance is noticed when moving the Clip Director knob
from side-to-side, excessive grass may have built up on top of the
sliding door.
IMPORTANT SAFETY PRECAUTION
Always turn the engine off and disconnect the spark plug cap before
lifting the discharge guard to view or clean around the sliding door.
This will prevent contact with the rotating blades and prevent objects
from being thrown into the discharge area.
Sliding Door Position
The sliding door [2] can be positioned to produce different mowing
results. If the preferred sliding door position is unknown, install a
grass bag and begin mowing with the Clip Director knob [1] all the
way to the BAG position. Check the appearance of the lawn. As the
knob is moved towards the MULCH position, more grass will be
recycled back into the lawn. Adjust the Clip Director knob until the
desired result is achieved.
Rear Discharge
To discharge clippings to the
rear, remove the grass bag
and position the Clip Director
knob [1] in the BAG range.
[1]
[1]
REAR SHIELD
DISCHARGE GUARD
[1]
[2] (fully closed)
DISCHARGE
GUARD
[1]
[2] (50% open)
BAGGING OR REAR DISCHARGE
AND SOME MULCHING
[2] (fully closed)
FULL BAGGING OR
REAR DISCHARGE
FULL MULCHING
[1] (BAG position)
[1] (MULCH position)
[2] (fully open)
[1]
HXE.book Page 8 Monday, August 6, 2007 10:44 AM
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Honda HRX537 HMEA at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Honda HRX537 HMEA in the language / languages: English as an attachment in your email.

The manual is 4,92 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info