Manual Honda HRD536 (page 37 of 92) (English, German, French)

473996

Zoom out

Zoom in

1/92

MISE EN MARCHE ET ARRÊT DU MOTEUR

NOTE :

• Pour régler la vitesse du moteur au cours du fonctionnement de la tondeuse, le levier de

commande des gaz peut être positionné n’importe où entre les positions “RAPIDE” [B] et

“LENT” [C]. On obtient cependant de meilleurs résultats sur la position “RAPIDE” [B].

• Le moteur peut caler si le levier est sur la position “LENT” [C], lors de l’engagement de

l’embrayage de lame.

• Pour faciliter le démarrage, placer la tondeuse sur une surface plane, sans herbe haute.

ARRÊT DU MOTEUR

1. Placer le levier de commande des gaz [1] sur la position “ARRÊT” [D].

2. Fermer le robinet d’arrivée d’essence [3].

1. Placer le levier de commande des gaz [1] sur la position “LENT” [C].

2. Tourner la clé de contact [2] sur la position “ARRÊT”.

3. Placer le levier de commande des gaz [1] sur la position “ARRÊT” [D].

4. Fermer le robinet d’arrivée d’essence [3].

MOTEUR NOYÉ

Si le moteur refuse toujours de démarrer après plusieurs tractions exercées sur le lanceur, il se

peut alors qu’il soit noyé.

Pour désengorger un moteur noyé :

1. Placer le levier de commande des gaz sur la position “ARRÊT” [D].

2. Retirer et sécher la bougie d’allumage. Lorsque l’on remet la bougie en place, la visser à la

main jusqu’à ce qu’elle soit en appui. Puis, avec la clé à bougie, la serrer d’1/8 à 1/4 de tour

supplémentaire pour bien comprimer la rondelle.

3. Mettre ensuite le levier de commande des gaz sur la position “RAPIDE” [B] et répéter les

opérations précédentes mentionnées à la rubrique “Mise en marche du moteur”, pages 33

et 35 § 2, 3, 4 et 5.

STARTING AND STOPPING THE ENGINE

NOTE:

• To adjust the engine speed when the mower is running, the throttle control lever can be set

anywhere between the “FAST” [B] and “SLOW” [C] positions. However, the best results are

obtained in the “FAST” position [B].

• The engine may stall if the lever is in the “SLOW” [C] position when the blade clutch is

engaged.

• To facilitate starting, place the mower on a flat surface where the grass is not long.

STOPPING THE ENGINE

1. Put the throttle control lever [1] in the “STOP” position [D].

2. Close the fuel shut-off valve [3].

1. Put the throttle control lever [1] in the “SLOW” position [C].

2. Turn the switch key [2] to the “OFF” position.

3. Put the throttle control lever [1] in the “STOP” position [D].

4. Close the fuel shut-off valve [3].

FLOODED ENGINE

If the engine still refuses to start after several pulls on the starter, the engine may be flooded.

To clear a flooded engine:

1. Place the throttle control lever in “STOP” position [D].

2. Remove and dry the spark plug. When refitting the spark plug, screw it up until it is finger

tight and correctly seated. Then using the plug spanner, tighten it an additional 1/8 to 1/4

turn so that the washer is correctly compressed.

3. Then put the throttle control lever in the “FAST” position [B] and repeat the previous

operations mentioned under the heading “Starting the engine”, pages 33 and 35 § 2, 3, 4,

and 5.

Hi, can you tell me what the guarantee is on the Honda hrd536 lawnmowers.
Thank you. Submitted on 15-9-2022 at 14:14
Reply Report abuse

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Honda HRD536 in the language / languages: English, German, French as an attachment in your email.

The manual is 2,31 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Honda HRD536

Honda HRD536 User Manual - Dutch, Italian, Spanish - 92 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Honda HRD536 Manual

Product: