459023
33
Zoom out
Zoom in
Previous page
1/88
Next page
33
MISE EN MARCHE ET ARRÊT DU MOTEUR
NOTE : Après le démarrage du moteur, remettre la clé sur la position “MARCHE” [E]. Ne pas
actionner le démarreur pendant plus de 5 secondes d’affilée. Si le moteur n’arrive pas à
démarrer, il faut alors relâcher la clé et attendre 10 secondes avant une nouvelle tentative.
Si le moteur refuse toujours de démarrer après plusieurs tentatives, utiliser le lanceur [4] : tirer
doucement sur la poignée jusqu’à sentir une résistance ; puis, tirer vivement.
NOTE :
Ne pas laisser le lanceur [4] revenir brutalement ; le ramener à la main.
4. Une fois que le moteur est chaud (Son fonctionnement est régulier lorsque l’on retire le
starter), mettre le levier de commande des gaz sur la position “RAPIDE” [B].
NOTE
:
Pour régler la vitesse du moteur au cours du fonctionnement de la tondeuse, le levier de
commande des gaz peut être positionné n’importe entre les positions “RAPIDE” [B] et
“LENT” [C]. On obtient cependant de meilleurs résultats sur la position “RAPIDE” [B].
Le moteur peut caler si le levier est sur la position “LENT” [C], lorsque l’embrayage de lame
est enclenché.
Pour faciliter le démarrage, placer la tondeuse sur une surface plane, sans herbe haute.
STARTING AND STOPPING THE ENGINE
NOTE: After the engine has started, put the key back on the “ON” position [E]. Do not operate the
starter for more than 5 seconds at a time. If the engine does not start, release the key and wait for
10 seconds before trying again.
If the engine does not start after several tries, use the recoil starter [4] : pull it slowly until a
resistance is felt; then pull sharply.
NOTE
: Do not let the starter [4] spring back suddenly on its own; guide it back slowly.
4. Once the engine has warmed up (The engine runs evenly when the accelerator lever is
moved away from the “CHOKE” position), set the throttle lever to “FAST” position [B].
NOTE:
To adjust the engine speed when the mower is running, the throttle lever can be set anywhere
between the “FAST” [B] and “SLOW” [C] positions. However, the best results are obtained in
the “FAST” position [B].
The engine may stall if the lever is in the “SLOW” position [C] when the blade clutch is
engaged.
To facilitate starting, place the mower on a flat surface where the grass is not long.
GB
F
33


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Honda HRB475 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Honda HRB475 in the language / languages: English, German, French as an attachment in your email.

The manual is 1,71 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Honda HRB475

Honda HRB475 User Manual - Dutch, Italian, Spanish - 88 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info