474001
79
Zoom out
Zoom in
Previous page
1/84
Next page
79
REMISAGE
PRÉPARATION POUR LE REMISAGE
Procéder aux opérations suivantes, afin de protéger la tondeuse
chaque fois qu’elle doit être remisée pour une période de plus de 30
jours.
Ne pas vidanger le réservoir d’essence alors que le pot d’échappement est chaud.
1. Vidanger le réservoir d’essence et le carburateur dans un récipient adéquat [1] :
a. Ouvrir le robinet d’essence [2].
b. Retirer la vis de vidange [3] pour vidanger le carburateur et le réservoir.
c. Revisser ensuite la vis.
d. Fermer le robinet d’essence.
2. Changer l’huile moteur (voir page 47).
3. Tirer le lanceur jusqu’à sentir une résistance. Cela permet de fermer les soupapes et de les
protéger de la poussière et de la corrosion.
4. Enduire les surfaces qui sont susceptibles de rouiller d’un léger film d’huile. Recouvrir la
tondeuse et la remiser sur un sol plan et dans un endroit sec, à l’abri de la poussière. Ne pas
utiliser de bâche en plastique, qui retiendrait l’humidité.
NOTE :
Si la tondeuse doit être remisée pendant une période de plus de 3 mois, retirer la bougie
d’allumage et verser2à5cm
3
d’huile moteur propre dans le cylindre, tirer ensuite doucement
deux ou trois fois le lanceur, afin de bien répartir l’huile. Ne pas laisser la tondeuse couchée sur le
côté pendant une longue période. Ceci peut être la cause d’un démarrage difficile du moteur et
d’une fuite de l’huile de transmission.
STORAGE
PREPARATIONS FOR STORING THE MOWER
Carry out the following operations to protect the mower each time it
is to be stored for a period of more than 30 days.
Do not drain the fuel tank while the muffler is hot.
1. Drain the fuel tank and the carburetor into a suitable receptacle [1]:
a. Open the fuel cock [2].
b. Remove drain plug [3] to drain carburetor and fuel tank.
c. Then refit the drain plug.
d. Close the fuel cock.
2. Change the engine oil (see page 47).
3. Pull the starter slowly until a resistance is felt. This closes the valves and protects them from
dust and corrosion.
4. Coat all surfaces liable to rust with a thin film of oil. Cover the mower and store it on a flat
surface in a dry, dust-free place. Do not use a plastic cover since this retains dampness.
NOTE:
If the mower is to be stored for a period of more than 3 months, remove the spark plug
and pour 2 to 5 cc of clean engine oil into the cylinder; then pull the starter rope slowly two or three
times to spread the oil. Do not leave the mower lying on its side over long periods. This may
cause difficult starting and gear oil leaks.
SECURITE
B3 D2 D3 D4
SAFETY
B3 D2 D3 D4
GB
WARNING :
F
79


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Honda HRB425C at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Honda HRB425C in the language / languages: English, German, French as an attachment in your email.

The manual is 1,85 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Honda HRB425C

Honda HRB425C User Manual - Dutch, Italian, Spanish - 84 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info