473997
37
Zoom out
Zoom in
Previous page
1/92
Next page
MISE EN MARCHE ET ARRÊT DU MOTEUR
NOTE :
Pour régler la vitesse du moteur au cours du fonctionnement de la tondeuse, le levier de
commande des gaz peut être positionné nimporte où entre les positions RAPIDE[B] et
LENT [C]. On obtient cependant de meilleurs résultats sur la position RAPIDE[B].
Le moteur peut caler si le levier est sur la position LENT[C], lors de lengagement de
lembrayage de lame.
Pour faciliter le démarrage, placer la tondeuse sur une surface plane, sans herbe haute.
ARRÊT DU MOTEUR
1. Placer le levier de commande des gaz [1] sur la position ARRÊT[D].
2. Fermer le robinet darrivée dessence [3].
1. Placer le levier de commande des gaz [1] sur la position LENT[C].
2. Tourner la clé de contact [2] sur la position ARRÊT.
3. Placer le levier de commande des gaz [1] sur la position ARRÊT[D].
4. Fermer le robinet darrivée dessence [3].
MOTEUR NOYÉ
Si le moteur refuse toujours de démarrer après plusieurs tractions exercées sur le lanceur, il se
peut alors quil soit noyé.
Pour désengorger un moteur noyé :
1. Placer le levier de commande des gaz sur la position ARRÊT[D].
2. Retirer et sécher la bougie dallumage. Lorsque lon remet la bougie en place, la visser à la
main jusquà ce quelle soit en appui. Puis, avec la clé à bougie, la serrer d1/8 à 1/4 de tour
supplémentaire pour bien comprimer la rondelle.
3. Mettre ensuite le levier de commande des gaz sur la position RAPIDE [B] et répéter les
opérations précédentes mentionnées à la rubrique Mise en marche du moteur, pages 33
et 35 § 2, 3, 4 et 5.
F
STARTING AND STOPPING THE ENGINE
NOTE:
To adjust the engine speed when the mower is running, the throttle control lever can be set
anywhere between the FAST[B] and SLOW[C] positions. However, the best results are
obtained in the FASTposition [B].
The engine may stall if the lever is in the SLOW[C] position when the blade clutch is
engaged.
To facilitate starting, place the mower on a flat surface where the grass is not long.
STOPPING THE ENGINE
1. Put the throttle control lever [1] in the STOPposition [D].
2. Close the fuel shut-off valve [3].
1. Put the throttle control lever [1] in the SLOWposition [C].
2. Turn the switch key [2] to the OFFposition.
3. Put the throttle control lever [1] in the STOPposition [D].
4. Close the fuel shut-off valve [3].
FLOODED ENGINE
If the engine still refuses to start after several pulls on the starter, the engine may be flooded.
To clear a flooded engine:
1. Place the throttle control lever in STOPposition [D].
2. Remove and dry the spark plug. When refitting the spark plug, screw it up until it is finger
tight and correctly seated. Then using the plug spanner, tighten it an additional 1/8 to 1/4
turn so that the washer is correctly compressed.
3. Then put the throttle control lever in the FASTposition [B] and repeat the previous
operations mentioned under the heading Starting the engine, pages 33 and 35 § 2, 3, 4,
and 5.
GB
37
37


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Honda HRA536 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Honda HRA536 in the language / languages: English, German, French as an attachment in your email.

The manual is 2,31 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Honda HRA536

Honda HRA536 User Manual - Dutch, Italian, Spanish - 92 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info