473997
25
Zoom out
Zoom in
Previous page
1/92
Next page
PRÉPARATION ET VÉRIFICATIONS AVANT UTILISATION
VÉRIFICATION DE LÉTAT DE LA LAME
PRÉCAUTION :
Ne pas incliner la tondeuse avec le carburateur orienté vers le bas ; il en résulterait un
redémarrage très difficile par la suite, dû à lobstruction du filtre à air par de lhuile moteur.
Pour vérifier létat de la lame :
1. Arrêter le moteur.
2. Retirer le capuchon de la bougie dallumage.
3. Mettre la tondeuse sur le côté [A], de telle sorte que le carburateur soit orienté vers le haut
(côté gauche).
Vérifier si la lame [1] présente des signes dusure et la remplacer, si cest nécessaire.
Vérifier le serrage des vis de lame [2] (voir chapitre Entretien).
Pour remplacer la lame ou effectuer une dépose-repose, se référer à la procédure décrite
au chapitre Entretien.
[3] LAME NEUVE [5] LAME VOILEE
[4] LAME EXCESSIVEMENT USAGEE [6] LAME FENDUE
Ne jamais faire fonctionner la tondeuse avec une lame usée ou endommagée, fendue ou
entaillée.
Un morceau de lame qui se casse et se trouve projeté peut être la cause de blessures
graves.
NOTE : Lusure de la lame est plus rapide, lorsque la tondeuse travaille sur des sols sablonneux.
Examiner très souvent la lame, en cas dutilisation de la tondeuse dans ces conditions.
F
PREPARATION AND CHECKS BEFORE USE
CHECKING BLADE CONDITION
CAUTION:
Do not tilt the mower with the carburettor facing down ; this will make the mower difficult to
start later, due to engine oil blocking the air cleaner.
To check blade condition:
1. Stop the engine.
2. Pull off the spark plug cap.
3. Place the mower on its side [A], so that the carburettor is facing upwards (left side).
Check if the blade [1] shows signs of wear or damage and replace it if necessary.
Check that blade screws [2] are tightened (see Maintenance chapter).
For blade replacement or removal/ installation, refer to the procedure described in the
Maintenance chapter.
[3] NEW BLADE [5] BENT BLADE
[4] EXCESSIVELY WORN BLADE [6] CRACKED BLADE
Never operate the mower with a worn, damaged, split or dented blade.
A piece of blade which breaks off and is thrown outwards can cause serious bodily
injuries.
NOTE: Blade wear is increased when the mower is used on sandy soils. Inspect the blade more
often when the mower is used in these conditions.
GB
25
25


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Honda HRA536 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Honda HRA536 in the language / languages: English, German, French as an attachment in your email.

The manual is 2,31 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Honda HRA536

Honda HRA536 User Manual - Dutch, Italian, Spanish - 92 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info