668076
71
Zoom out
Zoom in
Previous page
1/77
Next page
134 | | 135
SPECIFICATIONSMAINTENANCE
TABLE OF CONTENTS
INDEX
VISUAL INDEX
VOICE COMMAND
INDEX
SAFETY
INFORMATION
CUSTOMER
INFORMATION
INSTRUMENT PANEL
SPECIFICATIONS
VEHICLE
CONTROLS
MAINTENANCE
AUDIO AND
CONNECTIVITY
HANDLING THE
UNEXPECTED
BLUETOOTH®
HANDSFREELINK®
DRIVING
HONALINK®
NAVIGATION
Testing of Readiness Codes
Your vehicle has “readiness codes” as part of the onboard self-diagnostic system.
Some states refer to these codes as a test to see if your vehicle’s emissions
components are working properly. The codes may not be read if you go through the
emissions testing just after the battery has gone dead or been disconnected.
To check if they are set, turn the vehicle on without starting the engine. The
malfunction indicator lamp will come on for several seconds. If it goes off, the
readiness codes are set. If it blinks five times, the readiness codes are not set.
If you are required to have your vehicle emissions tested before the readiness codes
are set, prepare the vehicle for retesting by doing the following:
1. Fill the gas tank to approximately 3/4 full.
2. Park the vehicle and leave the engine off for 6 hours or more.
3. Make sure the ambient temperature is between 40°F and 95°F (4°C and 35°C).
4. Start the engine without touching the accelerator pedal, and let it idle for 20
seconds.
5. Keep the vehicle in Park (P) or Neutral (manual transmission). Increase the
engine speed to 2,000 rpm, and hold it there for about 3 minutes.
6. Let the engine idle with your foot off the accelerator for 20 seconds.
7. Select a nearby, lightly traveled major highway where you can maintain a speed
of 50 to 60 mph (80 to 97 km/h) for at least 20 minutes. Drive on the highway with
the vehicle in Drive (D) or 5th gear (manual transmission). Do not use cruise
control. When traffic allows, drive for 90 seconds without using the accelerator
pedal. (Vehicle speed may vary slightly; this is OK.) If you cannot do this for
a continuous 90 seconds because of traffic conditions, drive for at least 30
seconds, then repeat two more times (for a total of 90 seconds).
8. Drive in city/suburban traffic for at least 10 minutes. When traffic conditions
allow, let the vehicle coast for several seconds without using the accelerator
pedal or the brake pedal.
9. Park the vehicle and leave the engine off for 30 minutes.
The readiness codes are erased when the battery is disconnected, and set again
only after several days of driving under a variety of conditions.
If an emissions testing facility determines that the readiness codes are not set, you
may be requested to return at a later date to complete the test, or see your dealer.
Vehicle
Engine and Fuel
Tires
Light Bulbs
Fluids
*1: 2WD
No. of Passengers:
Front 2
Rear 3
Total5
Weights:
Gross Vehicle
Weight Rating
4,001 lbs (1,815 kg)
*1
4,166 lbs (1,890 kg)
*2
Gross Axle Weight
Rating (Front)
2,127 lbs (965 kg)
*1
2,178 lbs (988 kg)
*2
Gross Axle Weight
Rating (Rear)
1,873 lbs (850 kg)
*1
1,988 lbs (902 kg)
*2
Air Conditioning:
Refrigerant Type HFC-134a (R-134a)
Charge Quantity 14.3 - 16.0 oz (405 - 455 g)
Lubricant Type ND-OIL8
Displacement 109.8 cu-in (1,800 cm
3
)
Spark Plugs
NGKDILZKR7B11GS
DENSO DXU22HCR-D11S
Fuel:
Type
of 87 or higher
Regular
Pressure
psi (kPa[kgf/cm
2
])
Front 32 (220 [2.2])
Rear 30 (210 [2.1])
Compact
Spare
Size T135/90D16 102M
Pressure
psi (kPa[kgf/cm
2
])
60 (420 [4.2])
Wheel Size
Regular 17 x 7 1/2J
Compact Spare 16 x 4T
Fog Lights
*
35W (H8)
Side Marker Lights 5W
Front Turn Signal/Parking Lights28/8W (Amber)
Brake/Tail/Side Marker Lights LED
Back-Up Lights 16W
Rear Turn Signal Lights 21W (Amber)
High-Mount Brake Light LED
Side Turn Signal Lights
*
LED
Rear License Plate Lights5W
Interior Lights
Vanity Mirror Light
*
1.8W
Map Lights 8W
Ceiling Light 8W
Brake Fluid
Continuously Variable Transmission Fluid
*
*1: 2WD
*2: AWD
Manual Transmission Fluid
*
Specified Honda Heavy Duty Brake Fluid DOT 3
Specified Honda HCF-2 Transmission Fluid
Capacity Change
3.7 US qt (3.5 L)
*1
4.2 US qt (4.0 L)
*2
Specified Honda Manual Transmission Fluid
Capacity Change 2.0 US qt (1.9 L)
Engine Coolant
*1: Continuously variable transmission models
*2: Manual transmission models
Recommended
·Genuine Honda Motor Oil 0W-20
·API Premium-grade 0W-20 detergent oil
Capacity
Change 3.7 US qt (3.5 L)
Change
including
filter
3.9 US qt (3.7 L)
Specified Honda Long-Life Antifreeze/Coolant Type2
Ratio 50/50 with distilled water
Capacity
1.39 US gal (5.25 L)
*1
(change including the remaining
0.13 US gal (0.5 L) in the reserve tank)
1.38 US gal (5.24 L)
*2
(change including the remaining
0.13 US gal (0.5 L) in the reserve tank)
Washer Fluid
Tank Capacity
U.S.: 2.6 US qt (2.5 L)
Canada: 4.8 US qt (4.5 L)
d
*
Specified Honda Dual Pump Fluid II
Capacity Change 1.318 US qt (1.247 ℓ)
SPECIFICATIONS
*if equipped
71


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Honda HR-V 2016 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Honda HR-V 2016 in the language / languages: English as an attachment in your email.

The manual is 5,58 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info