13123
15
Zoom out
Zoom in
Previous page
1/60
Next page
Storage PrecautionsDraining the Fuel Tank and Carburetor
Engine Oil
Removal from Storage
TRANSPORTING
ENGLISH
ENGINE OIL FILLER CAP
PRIMING BULB
FUEL FILLER NECK
FUEL RETURN TUBE
15
If your engine will be stored with gasoline in the fuel tank and
carburetor, it is important to reduce the hazard of gasoline vapor
ignition. Select a well-ventilated storage area away from any
appliance that operates with a flame, such as a furnace, water
heater, or clothes dryer. Also avoid any area with a spark-
producing electric motor, or where power tools are operated.
If possible, avoid storage areas with high humidity, because that
promotes rust and corrosion.
Keep the engine level in storage. Tilting can cause fuel or oil
leakage.
With the engine and exhaust system cool, cover the engine to
keep out dust. A hot engine and exhaust system can ignite or melt
some materials. Do not use sheet plastic as a dust cover.
A nonporous cover will trap moisture around the engine,
promoting rust and corrosion.
Gasoline is highly flammable and explosive, and you
can be burned or seriously injured when handling
fuel.
Stop engine and keep heat, sparks, and flame away.
Wipe up spills immediately.
Handle fuel only outdoors.
Make sure the engine oil filler cap is tightened securely.
Remove the fuel filler cap and drain the fuel into an approved
gasoline container by tipping the engine toward the fuel filler
neck.
Press the priming bulb several times until there is no more fuel
in the fuel return tube.
Tip the engine toward the fuel filler neck again to drain the fuel.
After all fuel has drained, reinstall the fuel filler cap securely.
Change the engine oil (see page ).
Loosen the 5 mm hex bolt, then remove the top cover (see page
).
Remove the spark plug (see page ).
Apply a couple of drops of clean engine oil into the cylinder.
Install the top cover temporarily.
Pull the starter grip several times to distribute the oil in the
cylinder.
Remove the top cover, then reinstall the spark plug.
Install the top cover, and tighten the 5 mm hex bolt securely (see
page ).
Pull the starter grip slowly until resistance is felt.
Check your engine as described in the
BEFORE OPERATION
CHECKS
section of this manual (see page ).
If the fuel was drained during storage preparation, fill the tank with
fresh gasoline. If you keep a container of gasoline for refueling, be
sure it contains only fresh gasoline. Gasoline oxidizes and
deteriorates over time, causing hard starting.
If the cylinder was coated with oil during storage preparation, the
engine will smoke briefly at startup. This is normal.
If the engine has been running, allow it to cool for at least 15
minutes before loading the engine-powered equipment on the
transport vehicle. A hot engine and exhaust system can burn you
and can ignite some materials.
2.
1.
3.
1.
2.
3.
4.
5.
6.
4.
5.
7.
8.
9.
9
11
4
11
11
05/12/16 15:02:29 32Z6J600_015
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Honda Honda Engines GX35 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Honda Honda Engines GX35 in the language / languages: English as an attachment in your email.

The manual is 3,08 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Honda Honda Engines GX35

Honda Honda Engines GX35 User Manual - English - 60 pages

Honda Honda Engines GX35 User Manual - German, Dutch, Italian - 60 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info