13105
11
Zoom out
Zoom in
Previous page
1/60
Next page
ENGLISH
Cleaning
Dual-Filter-Element Types
Oil-Bath Type
GASKET
GASKET
PRECLEANER CAP
AIR CLEANER
COVER
PAPER FILTER
ELEMENT
FOAM FILTER
ELEMENT
WING NUT
STANDARD DUAL-FILTER-
ELEMENT TYPE
WING NUT
WING NUT
AIR CLEANER COVER
WING NUT
PAPER FILTER ELEMENT
FOAM FILTER ELEMENT
CYCLONE HOUSING
GROOVE
AIR GUIDE
TAB
SPECIAL PAN SCREW (3)
CYCLONE DUAL-FILTER-ELEMENT TYPE
GRID
CAP
WING NUT
OIL LEVEL
AIR CLEANER
COVER
FILTER
ELEMENT
AIR
CLEANER
CASE
11
Remove the wing nut from
the air cleaner cover, and
remove the cover.
Remove the wing nut from
the air filter, and remove the
filter.
Remove the foam filter from
the paper filter.
Inspect both air filter
elements, and replace them if
they are damaged. Always
replace the paper air filter
element at the scheduled
interval (see page ).
Clean the air filter elements if they are to be reused.
Paper air filter element: Tap the filter element several times on a
hard surface to remove dirt, or blow compressed air [not
exceeding 207 kPa (2.1 kgf/cm
, 30 psi)] through the filter
element from the inside. Never try to brush off dirt; brushing will
force dirt into the fibers.
Foam air filter element: Clean in warm soapy water, rinse, and
allow to dry thoroughly. Or clean in nonflammable solvent and
allow to dry. Dip the filter element in clean engine oil, then
squeeze out all excess oil. The engine will smoke when started if
too much oil is left in the foam.
CYCLONE TYPE ONLY: Remove the three pan-head screws from
the precleaner cap, then remove the cyclone housing and air
guide. Wash the parts with water, dry them thoroughly, and
reassemble them.
Be sure to install the air guide as shown in the illustration.
Install the cyclone housing so the air intake tab fits into the
groove in the precleaner cap.
Wipe dirt from the inside of the air cleaner case and cover, using
a moist rag. Be careful to prevent dirt from entering the air duct
that leads to the carburetor.
Place the foam air filter element over the paper element, and
reinstall the assembled air filter. Be sure the gasket is in place
beneath the air filter. Tighten the air filter wing nut securely.
Install the air cleaner cover, and tighten the wing nut securely.
Remove the wing nut, and remove the air cleaner cap and cover.
Remove the air filter element from the cover. Wash the cover
and filter element in warm soapy water, rinse, and allow to dry
thoroughly. Or clean in nonflammable solvent and allow to dry.
Dip the filter element in clean engine oil, then squeeze out all
excess oil. The engine will smoke if too much oil is left in the
foam.
Empty the used oil from the air cleaner case, wash out any
accumulated dirt with nonflammable solvent, and dry the case.
Fill the air cleaner case to the OIL LEVEL mark with the same oil
that is recommended for the engine (see page ).
Oil capacity:
Reassemble the air cleaner, and tighten the wing nut securely.
60 cm
(2.0 US oz , 2.1 Imp oz)
1.
2.
4.
3.
5.
6.
7.
8.
9.
7
1.
2.
4.
3.
5.
6.
8
05/06/17 17:25:32 32Z4F601_011
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Honda Honda Engines GX160 Regular at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Honda Honda Engines GX160 Regular in the language / languages: English as an attachment in your email.

The manual is 8,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Honda Honda Engines GX160 Regular

Honda Honda Engines GX160 Regular User Manual - German, Dutch - 60 pages

Honda Honda Engines GX160 Regular User Manual - Dutch - 33 pages

Honda Honda Engines GX160 Regular User Manual - Italian - 60 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info