13091
9
Zoom out
Zoom in
Previous page
1/48
Next page
−−
ENGLISH
Cleaning SPARK PLUG
Recommended Spark Plugs:
SPARK PLUG WRENCH
SEALING
WASHER
AIR CLEANER CASE
SCREWS
AIR CLEANER COVER
0.60 0.70 mm
(0.024 0.028 in)
SIDE ELECTRODE
PAPER AIR FILTER ELEMENT
SPARK PLUG CAP
FOAM AIR FILTER ELEMENT
(applicable types)
9
Inspect the spark plug.
Replace it if damaged or
badly fouled, if the sealing
washer is in poor condition,
or if the electrode is worn.
Measure the spark plug
electrode gap with a wire-
type feeler gauge. Correct the
gap, if necessary, by carefully
bending the side electrode.
The gap should be:
Install the spark plug carefully,
by hand, to avoid cross-
threading.
When installing a new spark plug, tighten 1/2 turn after the spark
plug seats to compress the washer.
When reinstalling the original spark plug, tighten 1/8 1/4 turn
after the spark plug seats to compress the washer.
A loose spark plug can overheat and damage the engine.
Overtightening the spark plug can damage the threads in the
cylinder head.
Attach the spark plug cap to the spark plug.
Remove two screws from the air cleaner cover, and remove the
cover.
Remove the foam air filter element from the cover.
Remove the paper air filter element from the air cleaner case.
Clean the air filter elements if they are to be reused.
Wipe dirt from the inside of the air cleaner case and cover using
a moist rag. Be careful to prevent dirt from entering the air duct
that leads to the carburetor.
Place the foam air filter element to the air cleaner cover, then
reinstall the paper air filter element and cover to the air cleaner
case.
Install the air cleaner cover, and tighten the two screws securely.
Inspect both air filter elements, and replace them if they are
damaged. Always replace the paper air filter element at the
scheduled interval (see page ).
CR5HSB (NGK)
U16FSR-UB (DENSO)
The recommended spark plug is the correct heat range for normal
engine operating temperatures.
An incorrect spark plug can cause engine damage.
For good performance, the spark plug must be properly gapped
and free of deposits.
Disconnect the spark plug cap, and remove any dirt from around
the spark plug area.
Remove the spark plug with a 5/8-inch spark plug wrench.
After the spark plug is seated, tighten with a 5/8-inch spark plug
wrench to compress the sealing washer.
Paper air filter element: Tap the paper air filter element several
times on a hard surface to remove dirt, or blow compressed air
[not exceeding 207 kPa (2.1 kgf/cm
, 30 psi)] through the filter
element from the air cleaner case side. Never try to brush off
dirt; brushing will force dirt into the fibers. Replace the paper air
filter element if it is excessively dirty.
Foam air filter element: Clean in warm soapy water, rinse, and
allow to dry thoroughly. Or clean in nonflammable solvent and
allow to dry. Do not put oil on the foam air filter element.
0.60 0.70 mm (0.024 0.028 in)
1.
2.
4.
3.
5.
6.
7.
8.
9.
1.
2.
3.
4.
5.
6.
7.
8.
6
06/01/24 10:13:54 32Z4E800_009
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Honda Honda Engines GX100 Rammer at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Honda Honda Engines GX100 Rammer in the language / languages: English as an attachment in your email.

The manual is 2,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Honda Honda Engines GX100 Rammer

Honda Honda Engines GX100 Rammer User Manual - German - 16 pages

Honda Honda Engines GX100 Rammer User Manual - Dutch - 16 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info