13079
8
Zoom out
Zoom in
Previous page
1/32
Next page
8
E
Fuel system damage or engine performance problems resulting from
neglected storage preparation are not covered under your engine
warranty (see last page).
You can extend fuel storage life by adding a gasoline stabilizer that is
formulated for that purpose, or you can avoid fuel deterioration
problems by draining the fuel tank and carburetor.
ADDING A GASOLINE STABILIZER TO EXTEND FUEL
STORAGE LIFE
When adding a gasoline stabilizer, fill the fuel tank with fresh gasoline.
If only partially filled, air in the tank will promote fuel deterioration
during storage. If you keep a container of gasoline for refueling, be
sure that it contains only fresh gasoline.
1. Add gasoline stabilizer following the manufacturers instructions.
2. After adding a gasoline stabilizer, run the engine outdoors for
10 minutes to be sure that treated gasoline has replaced the
untreated gasoline in the carburetor.
3. Stop the engine, and turn the fuel valve to the OFF position (see
page 2).
DRAINING THE FUEL TANK AND CARBURETOR
1. Place an approved gasoline container below the carburetor, and
use a funnel to avoid spilling fuel.
2. Remove the drain bolt, then move the fuel valve lever to the ON
position (see page 2).
3. After all the fuel has drained into the container, reinstall the drain
bolt and washer. Tighten the drain bolt securely.
Engine Oil
1. Change the engine oil
(see page 6).
2. Remove the spark plug
(see page 6).
3. Pour a tablespoon (5 – 10 cc) of
clean engine oil into the
cylinder.
4. Pull the recoil starter several
times to distribute the oil.
5. Reinstall the spark plug.
Storage Precautions
If your engine will be stored with gasoline in the fuel tank and
carburetor, it is important to reduce the hazard of gasoline vapor
ignition. Select a well-ventilated storage area away from any
appliance that operates with a flame, such as a furnace, water heater,
or clothes dryer. Also avoid any area with a spark-producing electric
motor, or where power tools are operated.
If possible, avoid storage areas with high humidity, because that
promotes rust and corrosion.
If there is gasoline in the fuel tank, leave the fuel valve in the OFF
position (see page 2).
Keep the engine level in storage. Tilting can cause fuel or oil leakage.
With the engine and exhaust system cool, cover the engine to keep
out dust. A hot engine and exhaust system can ignite or melt some
materials. Do not use sheet plastic as a dust cover. A nonporous
cover will trap moisture around the engine, promoting rust and
corrosion.
Removal From Storage
Check your engine as described in the BEFORE OPERATION
CHECKS section of this manual (see page 2).
If the fuel was drained during storage preparation, fill the tank with
fresh gasoline. If you keep a container of gasoline for refueling, be
sure it contains only fresh gasoline. Gasoline oxidizes and
deteriorates over time, causing hard starting.
If the cylinder was coated with oil during storage preparation, the
engine will smoke briefly at startup. This is normal.
TRANSPORTING
Keep the engine level when transporting to reduce the possibility of
fuel leakage. Turn the fuel valve to the OFF position (see page 2).
TAKING CARE OF UNEXPECTED PROBLEMS
WARNING
Gasoline is highly flammable and explosive, and you can
be burned or seriously injured when handling fuel.
Stop engine and keep heat, sparks, and flame away.
Refuel only outdoors.
Wipe up spills immediately.
FLOAT BOWL
DRAIN BOLT
WASHER
ENGINE WILL NOT
START
Possible Cause Correction
1. Check control
positions.
Fuel valve OFF. Move lever to ON.
Choke OFF. Move the choke/throttle
lever, choke rod or choke
lever to CHOKE ON
position unless engine is
warm.
Ignition switch or engine stop
switch OFF.
Move the flywheel brake
lever to RUN position.
(Types 2 & 6: Throttle lever
to FAST position. Type 5:
Engine stop switch to ON)
2. Check fuel. Out of fuel. Refuel.
Bad fuel; engine stored
without treating or draining
gasoline, of refueled with bad
gasoline.
Drain the fuel tank and
carburetor (p. 8). Refuel
with fresh gasoline.
3. Remove and inspect
spark plug.
Spark plug faulty, fouled, or
improperly gapped.
Replace the spark plug
(p. 6).
Spark plug wet with fuel
(flooded engine).
Dry and reinstall spark
plug. Start engine with
choke/throttle lever in
FAST position.
(Types 4 & 5: Choke OFF
position.)
4. Take engine to an
authorized Honda
servicing dealer, or
refer to shop manual.
Fuel filter clogged, carburetor
malfunction, ignition
malfunction, valves stuck,
etc.
Replace or repair faulty
components as necessary.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Honda Honda Engines GSV190 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Honda Honda Engines GSV190 in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 3,28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Honda Honda Engines GSV190

Honda Honda Engines GSV190 User Manual - English - 16 pages

Honda Honda Engines GSV190 User Manual - German, Dutch, Italian - 32 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info