with the hole in the shaft and insert the pin supplied (3) using a hammer, ensuring
that the end comes completely through to the opposite side.
To avoid damaging the steering wheel, use a punch of the
same size to push the pin in the last part.
3.3 FITTING THE SEAT
Mount the seat (1) on the plate (2) using
the screws (3).
Raise the adjustment lever (3) and fit the
seat (1) in the slide (2), introducing it
from the steering wheel’s side, till the
seat engages in one of the 6 positions.
At this point the seat is engaged and
cannot be removed unless the lever (4) is
pressed, freeing it from its retainer.
3.4 FRONT BUMPER ASSEMBLY (if fitted)
Fit the front bumper (1) on the lower part of
the frame (2) using the four screws (3).
3.5 CONNECTING THE BATTERY
The battery (1) is situated behind the engine and is held in place by an elastic
strap (2). Unhook the elastic strap (2), remove the battery and its protective cover
(3) and pour the electrolytic solution (4) (Acid not supplied: specific gravity 1,280
HF2•••◊TEHF2•••◊ME
➤
HF2•••◊BE
➤
NOTE
EN 10 UNPACKING AND ASSEMBLY
