580732
13
Zoom out
Zoom in
Previous page
1/16
Next page
1.Remove the carburetor drain bolt (1) with a 10 mm wrench, and
drain the carburetor bowl fuel (2) into an approved gasoline
container.
2.Move the throttle lever to fast position. This will allow the fuel
tank to drain through the carburetor bowl (2).
3.After draining the carburetor and fuel tank, tighten drain bolt
securely.
Engine oil
1.Change the engine oil (see page 19).
2.Remove the spark plug (see page 22), and pour a tablespoon
(5 - 10 cc) of clean engine oil into the cylinder. Using the recoil,
crank the engine a few revolutions to distribute the oil in the
cylinder, then reinstall the spark plug.
Storage
If your engine will be stored with gasoline in the fuel tank and
carburetor, it is important to reduce the hazard of gasoline vapor
ignition. Select a well-ventilated storage area away from any
appliance that operates with a flame, such as furnace, water
heater, or clothes dryer. Also avoid any area with a
spark-producing electric motor, or where power tools are
operated.
If possible, avoid storage areas with high humidity, because that
promotes rust and corrosion.
If there is gasoline in the fuel tank, leave the throttle lever in the
OFF position (GXV140).
Leave the fuel valve in the OFF position (GXV160K1).
Keep the engine level in storage. Tilting can cause fuel or oil
leakage.
With the engine and exhaust system cool, cover the engine to
keep out dust. A hot engine and exhaust system can ignite or melt
some materials. Do not use sheet plastic as a dust cover. A
nonporous cover will trap moisture around the engine, promoting
rust and corrosion.
Removal from Storage
1.Check your engine as described in the pre-operation checks
section of this manual (See page 7).
2.If the fuel was drained during storage preparation, fill the tank
with fresh gasoline. If you keep a container of gasoline for
refueling, be sure it contains only fresh gasoline. Gasoline
oxidizes and deteriorates over time, causing hard starting.
3.If the cylinder was coated with oil during storage preparation, the
engine will smoke briefly at startup. This is normal.
ATTENTION traits de coupes ancrés à un cadre automatique.
Positions : Gauche : 4.1 Haut : 3
2827
(1)
(2)
GXV140
(2)
(1)
GASKET
GXV160K1
FUEL VALVE
ON
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Honda GXV160K1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Honda GXV160K1 in the language / languages: English as an attachment in your email.

The manual is 0,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Honda GXV160K1

Honda GXV160K1 User Manual - German - 16 pages

Honda GXV160K1 User Manual - Dutch - 16 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info