551036
2
Zoom out
Zoom in
Previous page
1/13
Next page
2 of 13
INSTALLATION
CAUTION
To prevent burns, allow the engine, exhaust system,
radiator, etc. to cool before installing the accessory.
NOTE:
Disconnect the throttle cable from the right grip as
instructed in the motorcycle’s Service Manual.
For secure adhesion of the grip heaters use the
recommended adhesive agent (Honda Bond A) or
equivalent.
Be sure to open and close the throttle to check for
smooth operation after installation of the right grip
heater.
Disconnect the negative (-) cable from the battery
before installing this accessory.
After turning the ignition switch OFF, wait more than
10 seconds and then remove the negative cable of
the battery.
The memories of the tripmeter and clock will be
erased when you disconnect the battery. Reset the
clock after reconnecting the battery.
Reinstall the removed parts on the motorcycle and
make sure that the wires and harnesses are not
pinched.
Trim the excess ends off the wire ties after attaching
them to the wire harnesses. Do not allow the cut part
of the wire tie to interfere with another harness or
brake pipe.
After grip heater installation, check the lights (e.g.
right / left turn signal lights and brake lights) for
proper operation.
1. Open the left saddlebag lid as shown.
2. Remove the left side cover, and disconnect the
negative (-) cable from the battery.
LEFT SADDLEBAG LID
LEFT SIDE COVER
3. Also remove the right side cover.
4. Remove the motorcycle’s parts as shown.
BOLT
BOLT
WASHER
WASHER
RIGHT PASSENGER GRIP
BOLT
WASHER
LEFT
PASSENGER
GRIP
SEAT
FLANGE COLLAR
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Honda Goldwing F6B Grip Heater at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Honda Goldwing F6B Grip Heater in the language / languages: English as an attachment in your email.

The manual is 1,51 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info