625326
9
Zoom out
Zoom in
Previous page
1/64
Next page
9
SAFETY INSTRUCTIONS
C3.When tilling on a slope, ensure that the fuel tank is no more than half full in order to minimize the splashing of fuel.
C4.Switch off the engine and disconnect the spark plug cable in the following cases:
- Before performing any servicing action on the rotating implements.
- Before cleaning, checking, adjusting or repairing the tiller.
- After striking any object. In this case, inspect the machine to make sure it has not been damaged. Make any
necessary repairs before resuming work with the machine.
- If the tiller starts vibrating abnormally, look for the cause of the vibrations immediately and carry out the necessary
repairs.
C5.Switch off the engine in the following cases:
- Whenever the tiller is left unattended.
- Before refilling the fuel tank.
C6.Tread carefully on slopes. When working on slopes, always proceed crosswise, never straight up or down.
C7.When engaging the rotating implements, make sure there is no-one in front of or near the tiller. Hold the handlebar
firmly: it tends to rise when the clutch is released. Take special care when using the machine in reverse motion.
C8.When operating the machine, comply with the required safety distance from the rotating implements which is
indicated by the length of the handlebar.
C9.Never modify the adjustment of the engine speed controller or allow the engine to race.
C10.Work by daylight only or in good quality artificial lighting.
C11.When operating the machine on sloping ground, make sure there is no-one within a radius of 20 metres of the
machine. It is also essential to remain in position at the controls on the handlebar.
C12.Take special care when operating the machine on very hard or very stony ground as it will tend to be much less
stable than on cultivated ground.
MAINTENANCE AND STORAGE
D1.Wear heavy gloves when removing and installing the rotating implements.
D2.Do not use the tiller with damaged or worn parts. Parts must be replaced, not repaired. Use genuine original
manufacturer's parts. Parts of inferior quality may damage the machine and compromise your safety. Replace faulty
exhaust silencers.
D3.To avoid any risk of fire, allow the engine to cool before placing the tiller in storage.
D4.Once the engine is cool, remove plant residues from the tiller before placing it in storage.
D5.If the fuel tank has to be drained, this operation must be performed outdoors when the engine is cold.
D6.Store the tiller in a dry place. Never store the tiller with fuel in the fuel tank in a room where fuel vapours could be
ignited by a flame or a source of intense heat. Let the engine cool down before putting away the machine in any
room.
D7.Switch off the engine when the tiller is to be transported. Wear gloves to protect your hands and make sure the
machine does not over-balance.
D8.Keep all nuts and bolts securely tightened to ensure safe operation. Regular maintenance is required to ensure
safety and optimal performance.
D9.If the machine is to be loaded into a car, you must use the machine's transport wheel and a ramp in order to place it
in the car boot or a trailer.
D10.The tiller can be used equipped with certain accessories. It is the owner's responsibility to ensure that those
accessories or tools are certified to be in conformance with the applicable European safety regulations. Using
uncertified accessories may compromise your safety.
D11.Carefully read the installation and operating manual supplied with the accessory before using it.
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Honda FG205 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Honda FG205 in the language / languages: English, French as an attachment in your email.

The manual is 0,95 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Honda FG205

Honda FG205 User Manual - German - 14 pages

Honda FG205 User Manual - Dutch - 14 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info