625066
21
Zoom out
Zoom in
Previous page
1/49
Next page
AC operation
1. Start the engine.
2. Turn the AC/DC (Weld) selector switch to AC position.
CAUTION: Under no circumstances should any type of electrical appliance
be plugged into any of the AC receptacles when the selector is in the DC
(WELD) position. AC voltage is present at the AC receptacles at all times
regardless of the position of the AC/DC (WELD) selector. However, when
this selector is in the DC (WELD) position, the AC voltage is unregulated
and fluctuates considerably.
3. Switch on the AC circuit breaker.
4. Plug in the appliance.
CAUTION:
l
Do not connect the generator/welder to a household circuit. This could
cause damage to the generator or to electrical wiring and appliances in
the house.
l
For continuous operation, do not exceed the rated load capacity
(EW140: 3.0 KVA, EW171: 4.0 KVA). In either case, be sure to con-
sider the total power requirements of all connected applianc&. Do not
exceed the current limit specified for any one receptacle. Substantial
overloading will switch off the circuit breaker. Marginal overloading may
not switch off the circuit breaker, but it will shorten the service life of
the generator/welder.
l
If an overloaded circuit causes the AC circuit breaker to switch off,
reduce the electrical load on the circuit, and wait a few minutes before
resetting the circuit breaker.
l
Be sure that all appliances are in good working order before connecting
them to the generator. If an appliance begins to operate abnormally,
becomes sluggish, or stops suddenly, turn off the circuit breaker and the
engine switch immediately. Then disconnect the appliance and examine
it for signs of malfunction.
l
Most appliance and power tool motors require more than the rated
operating current for start-up. To match appliance power needs to
generator capability, allow a sufficient generator power reserve to ac-
comodate motor start-up requirements.
NOTE: Appliance and power tool manufacturers usually list rating informa-
tion near the model number or serial number.
AC/DC (WELD)
S
lector
19
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Honda EW140 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Honda EW140 in the language / languages: English as an attachment in your email.

The manual is 2,19 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info