473946
7
Zoom out
Zoom in
Previous page
1/14
Next page
7 EN
OPERATION
NOTE: Do not use the voltage change over switch while the
alternator is on load. This may create a failure of the switch.
1. Models EC2000 B, EC3600 B, EC5000 B
: select the appropriate
voltage using the voltage selector [2].
2. Connect machines to the receptacles, taking care not to exceed
the maximum current specified for each receptacle.
3. Ensure that the circuit breaker is reset.
MAINTENANCE
ENGINE OIL CHANGE
CAUTION:
Prolonged and frequent contact with used engine oil can cause
skin cancer. Although this is unlikely, it is sensible to wash your
hands thoroughly after handling used engine oil.
Drain the oil while the engine is still warm so that the oil flows out
quickly and completely.
1. Remove the oil filler cap [3] and the drain plug [4].
2. Drain the oil in an appropriate container.
3. Put the drain plug [4] back on, complete with its ring seal [5] and
tighten fully.
4. Refill with a recommended oil (see page 4) type and check that
the oil is level with the filler neck.
Oil capacity:
EC2000 : 0,6 l
EC3600 - EC5000 - ECT7000 : 1,1 l
NOTE:
Protection of the environment: Waste oil is a serious source of
pollution of our environment; we strongly recommend that you take
it in a leak-proof container to a service station or a waste disposal
site, which will recycle it. Do not throw oil away with household
waste, and do not dispose of it by pouring it away on the ground or
down the drain.
AIR CLEANER MAINTENANCE
The engine will not run properly if the air cleaner is dirty: it is very
important that the air cleaner is serviced regularly.
Never use petrol or inflammable solvents to clean air cleaner
elements: these products can cause fire and damage the air
cleaner elements.
EC2000
1. Remove the wing nut [6] and the
air cleaner cover [7]. Remove the
wing nut [8] and remove the
elements [9] and [10] and
separate them. Check carefully
that the elements are not torn or
blocked; replace them if they are
damaged.
2. Paper element [9]:
Tap the
element lightly several times on a
hard surface to get rid of any
loose dirt, or blow through with
compressed air from the inside
towards the outside. Never brush
the element, as this causes
impurities to penetrate the fibres.
Replace the paper element if it is
very dirty.
3. Foam element [10]
:
- wash the element in a solution
of warm water containing non-
foaming household detergent, rinse it and allow it to dry
thoroughly,
- dip the element in clean engine oil, then squeeze it to remove
excess oil. If too much oil is left in the foam, the engine will
smoke the next few times it is started.
4. Refit the ring seal [11], the air cleaner elements [9] and [10] the
wing nut [8], and the cover [7] and tighten the wing nut [6] fully.
CAUTION:
Do not use the generator without its air cleaner, as this can
damage the engine.
EC3600 / EC5000 / ECT7000
1. Remove the wing nut [12] and the
air cleaner cover [13]. Remove the
wing nut [16], remove the
elements [14] and [15] and
separate them. Check carefully that
the two elements are not torn or
blocked; replace them if they are
damaged.
2. Paper element [14]:
Tap the
element lightly several times on a
hard surface to get rid of any loose
dirt, or blow through with
compressed air from the inside
towards the outside. Never brush
the element, as this causes
impurities to penetrate the fibres.
Replace the paper element if it is
very dirty.
3. Foam element [15]
:
- wash the element in a solution of warm water containing non-
foaming household detergent, rinse it and allow it to dry
thoroughly, or clean it in a nonflammable solvent and allow it
to dry thoroughly,
- dip the element in clean engine oil, then squeeze it to remove
excess oil. If too much oil is left in the foam, the engine will
smoke the next few times it is started.
4. Refit the air cleaner element [14] and [15] the wing nut [16], and
the cover [13] and tighten the wing nut [12] fully.
CAUTION:
Do not use the generator without its air cleaner, as this can
damage the engine.
[4]
[3]
[5]
[7]
[6]
[9]
[10]
[11]
[8]
[12]
[13]
[14]
[15]
[16]
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Honda ECT7000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Honda ECT7000 in the language / languages: English as an attachment in your email.

The manual is 2,2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Honda ECT7000

Honda ECT7000 User Manual - German - 14 pages

Honda ECT7000 User Manual - Dutch - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info