473950
15
Zoom out
Zoom in
Previous page
1/24
Next page
15
GENERATING SET USE
Avoid overloading the generating set; the following rules must be respected if the
generating set is to perform properly:
- the sum of the power outputs of the machines connected simultaneously to the
generating set must be compatible with the characteristics given in the last pages
of this manual,
- some appliances draw more power when starting up than their nominal power
rating (electric motors and compressors are examples). We recommend that you
contact a Honda dealer in case of doubt,
- do not exceed the maximum current specified for each receptacle.
The generating set must not be loaded to its nominal power if conditions are such
that the normal cooling requirements are not met (atmospheric pressure: 100 kPa [1
bar]). When using the generating set in unfavourable conditions, take care to reduce
the power load. Example: 28 A (limited to X A by the circuit breaker).
INFORMATION ON THE CONSTRUCTION OF THE GENERATING SET
The generator windings are not connected to the earth; the system is thus safe by
construction and limits the risks of electrocution. It is strictly forbidden to connect the coils
to the generator earth, except when using a 30 mA differential circuit breaker for the
protection of persons. The installation of such a device must be carried out by a specialist
electrician and requires all appliances to be earthed.
The differential circuit breaker acts as a check against faulty insulation. It cuts off the power
when there is a detectable fault in the insulation between a voltage-bearing conductor and
any part of the earth, on the output side of the differential circuit breaker.
ECT6500 (230/400V)
The three 230 V single-phase receptacles are connected in parallel to the terminals of a
winding specially reinforced to withstand a current of 20 A. The single-phase 230 V power
output given on the rating plate, and also indicated in the table of characteristics, is
available only on these receptacles and when no other three-phase load is connected to
the generator’s outputs. Never connect the generator’s three-phase receptacle to a single-
phase splitter box.
When using simultaneously 230 V single-phase and 400 V three-phase current, the current
intensity per phase must not exceed 10 A.
Ex: Power available from receptacles for simultaneous three-phase and single-phase use.
Three-phase 0 3000 W 4000 W 5000 W 6000 W 7000 W
Single-phase 4500 W 1300 W 950 W 650 W 300 W 0
OMec_GB.book Page 15 Vendredi, 21. octobre 2005 3:05 15
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Honda EC6000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Honda EC6000 in the language / languages: English as an attachment in your email.

The manual is 1,06 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Honda EC6000

Honda EC6000 User Manual - German - 24 pages

Honda EC6000 User Manual - Dutch - 24 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info