473945

Honda EC5000 Manual

6
Zoom out
Zoom in
Previous page
1/14
Next page
6 EN
• Value for an admissible voltage drop on-line of 7 V and an
admissible current of 7 A per mm
2
of cable section:
- ambient temperature: 20 °C,
- completely unwind the cable to avoid deterioration of the
insulation by over-heating,
- comply with the cable manufacturer’s instructions.
• This generator is not recommended for use with electronic
apparatus, such as televisions, hi-fis, or microcomputers,
which might not be compatible with it.
• Avoid overloading the generator; the following rules must be
respected if the generator is to perform properly:
- the sum of the power outputs of the machines connected
simultaneously to the generator must be compatible with
the characteristics given in the page 10 of this manual,
- some appliances draw more power when starting up than
their nominal power rating (electric motors and
compressors are examples). We recommend that you
contact a Honda dealer in case of doubt,
- do not exceed the maximum current specified for each
receptacle.
• The generator must not be loaded to its nominal power if
conditions are such that the normal cooling requirements
are not met (atmospheric pressure: 100 kPa [1 bar]).
• When using the generator in unfavourable conditions, take
care to reduce the power load.
Example: 28 A* (* limited to x A by the circuit breaker).
INFORMATION ON THE CONSTRUCTION OF THE
GENERATOR
• The generator windings are not connected to the earth; the
system is thus safe by construction and limits the risks of
electrocution. It is strictly forbidden to connect the coils to the
generator earth, except when using a 30 mA differential circuit
breaker for the protection of persons. The installation of such a
device must be carried out by a specialist electrician and requires
all appliances to be earthed.
• The differential circuit breaker acts as a check against faulty
insulation. It cuts off the power when there is a detectable fault in
the insulation between a voltage-bearing conductor and any part
of the earth, on the output side of the differential circuit breaker.
ECT7000 (230/400 V)
• The three 230 V single-phase receptacles are connected in
parallel to the terminals of a winding specially reinforced to
withstand a current of 20 A. The single-phase 230 V power output
given on the rating plate, and also indicated in the table of
characteristics, is available only on these receptacles and when
no other three-phase load is connected to the generator outputs.
Never connect the generator three-phase receptacle to a
singlephase splitter box.
When using simultaneously 230 V single-phase and 400 V three-
phase current, the current intensity per phase must not exceed
10 A.
Ex: Power available from receptacles for simultaneous three-phase
and single-phase use.
• This type of generator is fitted with a thermal circuit breaker which
acts as a protection against overload. If the distribution of electric
current is interrupted during use, this might be caused by an
overload tripping the thermal circuit breaker. If this happens, wait
a few moments, eliminate the cause of the overload, then reset
the circuit breaker by pressing the button [1] sited near to the AC
receptacles. The thermal circuit breaker is rated according to the
specifications of the machine; if it needs replacing, use an original
Honda component.
Three-phase
0 3000 W 4000 W 5000 W 6000 W 7000 W
Single-phase
4500 W 1300 W 950 W 650 W 300 W 0
GV-F-W
[1]
B
[2] [1]
IT
[1]
EC2000
B
[1]
[2]
GV
[1]
IT
[1]
F
[1]
EC3600
IT F
GV
ECT7000
[1]
[1]
[1]
IT
GV F
B
[1]
[2]
[1]
[1]
EC5000
[1]
… 6 …


Need help? Post your question in this forum.

Forumrules
1

Forum

honda-ec5000

Reset search

  • Regarding Honda EC5000. There is no voltage output and the voltage meter shows 0. If there is a reset button, where is it located? Submitted on 22-11-2022 at 23:00

    Reply Report abuse

  • Model EC5000EX. There is no voltage output? If there is a reset button, where is it located? Submitted on 22-11-2022 at 22:54

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Honda EC5000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Honda EC5000 in the language / languages: English as an attachment in your email.

The manual is 2,2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Honda EC5000

Honda EC5000 User Manual - German - 14 pages

Honda EC5000 User Manual - Dutch - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info