Battery installation:
1. Put the battery in the battery box.
Be sure to connect the positive (+) terminal
first, then the negative (-) terminal.
2. Install the battery stopper(1), the washer(2)
and the bolt (3).
Washer position is different by battery type
as shown in the picture.
3. Tighten the bolt (3) to a torque of:
Torque battery stopper bolt:
27 N•m (2,80 kgf•m, 20 lbf•ft)
If a torque wrench was not used for
installation, see your Honda dealer as soon
as possible to verify proper assembly.
4. Be careful to install the front seat bracket
and the rear seat bracket of adjusting
regulation seat height (page 60).
5. Make sure the rubber sheet (4) position as
shown.
Install the rider seat (page 59).
If you remove and install the battery, see your
Honda dealer as soon as possible to verify
proper assembly.
123
(1) Battery stopper
(2) Washer
(3) Battery stopper bolt
(4) Rubber sheet
(4)
(2)
(2)
(3)
(1)
Battery type
FTZ10S
Battery type
YTZ10S
NOTICE