808732
39
Zoom out
Zoom in
Previous page
1/51
Next page
39
Start-up
5.2 Installation
The bus is powered by the Homematic IP Wired
Access Point (HmIPW-DRAP). For further
information, please refer to the operating manual
of the corresponding Wired Access Points.
To facilitate connection to the terminals, the
green push-in terminal can be removed from the
device. To do this, release the mounting plate,
press the latch on the back next to the lock sym-
bol and slide the clamp out of the mounting plate
to the side (see figure 2).
For the installation, please proceed as follows:
Disconnect the corresponding line of the
incoming Homematic IP wired bus.
Connect the Homematic IP wired bus to the bus
connecting terminals (see figure 3). To connect
and loosen the single wires, press the orange
clamp using a small screwdriver.
Place the mounting plate (A) in the flush-
mounted box and fasten it to the flush-mounted
box using the screws supplied (see figure 4).
Place the frame of your existing switch series or
the supplied clip-on frame (B) to the mounting
plate (see figure 5).
Place the electronic unit (C) of the motion
detector into the frame by fully snapping the
39


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for HomeMatic HmIPW-SMI55-A at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of HomeMatic HmIPW-SMI55-A in the language / languages: English, German as an attachment in your email.

The manual is 5.03 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info