808571
43
Zoom out
Zoom in
Previous page
1/58
Next page
43
Start-up
6.2 Installation
For comfortable installation you can pull the ca-
ble through the cable inlets after having removed
the breakout openings.
To install the switch actuator, please proceed as follows:
Open the cover
(B)
. Therefore, unscrew both
lower screws with an appropriate screwdriver and
remove the cover afterwards (
see fig. 2+3).
Connect the phase conductor to connecting ter-
minal L (C).
Connect the neutral conductor to connecting
terminal N (D).
Connect the protective conductor to connecting
terminal PE (E).
Connect e.g. the boiler to connecting terminal 1
(F) or a circulation pump to the connecting ter-
minals of the switching channel 2 (G).
You can expand the installation depending on the
installation conditions or according to your per-
sonal needs. For further information regarding the
connection options, please refer to section „6.3
Connections“ on page 44.
Close the cover again. Therefore, push the latch-
es of the cover into the openings provided and
fasten the screws.
43


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for HomeMatic HmIP-WHS2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of HomeMatic HmIP-WHS2 in the language / languages: English, German as an attachment in your email.

The manual is 5.54 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info