808718
44
Zoom out
Zoom in
Previous page
1/53
Next page
44
Replacing batteries
To replace the batteries of the motion detector, please
proceed as follows:
Once mounted, the electronic unit
(B)
of the
motion detector can easily be pulled out of the
frame (A) and removed from the mounting plate
(G)
.
To remove the electronic unit from the frame,
take hold of the sides of the electronic unit and
pull it out
(see figure 6)
.
You do not need to open
the device.
Turn the electronic unit over to remove the bat-
teries.
Insert two new 1.5 V LR03/micro/batteries into
the battery compartment, making sure that you
insert them the right way round
(see figure 7)
.
Put the electronic unit back into the frame. Make
sure that “TOP” and the arrows on the back side
of the electronic unit point upwards and that the
clips on the mounting plate latch into the open-
ings on the electronic unit.
Please pay attention to the flashing signals of the
device LED while inserting the battery (see „10.4 Er-
ror codes and flashing sequences“ on page 47).
Once the battery has been inserted, the motion detector
will perform a self-test (approx. 2 seconds). Afterwards,
initialisation is carried out. The LED test display will indi-
cate that initialisation is complete by lighting up orange
and green.
44


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for HomeMatic HmIP-SMI55-A at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of HomeMatic HmIP-SMI55-A in the language / languages: English, German as an attachment in your email.

The manual is 3.88 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info