650400

HomeMatic HM-Sec-SFA-SM Manual

27
Zoom out
Zoom in
Previous page
1/40
Next page
27
6 Mounting and installation
6.1 Mounting
The radio-controlled alarm siren and ash actuator is housed inside a
surface-mounting enclosure whose IP 65 protection also ensures suitabi-
lity for mounting outdoors and in damp locations.
However, the device should be mounted in such a way that
unauthorised parties cannot gain access to it.
We therefore recommend mounting the device inside the item of proper-
ty to be protected, in a location that is easy to access for the owner but
cannot be accessed by unauthorised parties.
The mounting location should be selected so that the line to the si-
gnalling device is as short as possible and the device is located within
the wireless range of the triggering Homematic device, e.g. the central
control unit or a sensor.
• The mounting position of the device must match that shown on
page 6/7; the recess for the battery must point downwards.
• The device is fastened to the wall through the four holes drilled in
the corners of the housing.
Make sure that the wall is able to carry a load at the points
where you have marked your bore holes and that no electricity,
gas, water or drain lines, etc. run there.
•
Furthermore, the device rear panel is fastened to the wall using an
additional screw which must be tted with the rubber seal included
in the package contents. This screw provides protection against the
device being removed from the mounting location unnoticed.
The bore hole is located in the battery compartment. Please use
the rubber seal included in the scope of supply when mounting the
device.
Once mounting is complete, the front panel will have to be removed
in order to gain access to this screw. If the front panel is removed,
the tamper sensor will trigger a warning message which is sent to
the central control unit.
… 27 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for HomeMatic HM-Sec-SFA-SM at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of HomeMatic HM-Sec-SFA-SM in the language / languages: English, German as an attachment in your email.

The manual is 1,31 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info