Manual Homedics WFL-ROC-2 (page 4 of 29) (English, German, Dutch, French, Italian, Polish, Spanish)

518474

Zoom out

Zoom in

1/29

TROUBLESHOOTING :

If the pump fails to operate, check the following:

Check the circuit breaker, or try a different outlet to make sure the pump is getting electrical

power.

NOTE: Always disconnect from electrical outlet before handling the pump.

Check the pump discharge and tubing for kinks and obstructions. Algae build up can be flushed

out with a garden hose.

Remove the pump inlet to access the impeller area. Turn the rotor to ensure it is not broken or

jammed.

Monthly maintenance will add to your pump’s life.

NOTE: Ensure that the electrical cord loops below the electrical outlet to form a ‘Drip Loop’. This

will prevent water from running down the cord into the electrical outlet.

If the pump gurgles, spews, or “burps”:

Check the water level to make sure the pump has enough water to function.

Obtaining a desired water level:

Check the water level daily the first week to measure the rate of evaporation; refill with water as

needed.

If water is splashing outside the fountain:

Rocks that are hit by water and also touch the edge of the base will cause water to splash

outside of the base and contribute to the splash factor. Expect some splash to occur as you get

the rocks organized.

If splash continues, adjust the flow control valve to a lower setting, and/or rearrange

the river rocks by moving them away from the edge of the base.

CAUTION:

All servicing of this fountain must be performed by authorized HoMedics

service personnel only.

ATTENTION:

In order to get best results, please operate pump completely submerged.

Keep the water level above the minimum water level ALL THE TIME.

MAINTENANCE :

To clean the pump:

Unplug from electrical

outlet. Remove it from the

base of the fountain. Use

a small brush or stream

of water to remove any

debris (Fig 9).

To keep water

clean:

Periodically change

water and clean the

product according to the

water condition. Keeping

the water clean prevents

the water from becoming

sticky and forming

micro-organisms.

Minimum Water Level

Flow Control Valve

(+)faster water

output

(-) slower water

output

Figure 8

Figure 9

Front Plate

PVC Tubing

Inserts Here

Back Plate

Suction Feet

Impeller

Pump Inlet

Flow

Control

Lever

Housing

To clean off hard water deposits on the base or rocks:

Soak the container and rocks in a mixture of vinegar and water to clean and remove any mineral

build-up.

Keeping the water at an optimum level:

Add water periodically to keep water level at an optimum level to avoid shortening the life of the

pump.

NOTE: Never let the pump run dry, as this will shorten the life of the pump.

Fountain Storage

Unplug the fountain from the electrical outlet, empty the water, and store rocks and fountain in a

dry, cool place.

Changing Light bulb

First unplug fountain and let bulb cool down. Remove the bulb cover by holding glass bulb

cover in dry hand and rubber neck with other hand. Slowly pull apart. Slight twisting may help to

loosen. Be gentle with bulb cover since it is glass. Never pull on cord. Next pull bulb straight out

and replace with new bulb, inserting prongs into the holes. Replace bulb cover securely.

Plug (MODEL WFL-ROC-3GB ONLY)

If the plug on this appliance is damaged, it can be replaced

with a BS 1363 plug, fitted with a 3A BS 1362 fuse.

Only use a 3amp fuse with this appliance.

Care must be taken when changing the plug.

If in doubt, contact a qualified electrician.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Homedics WFL-ROC-2 in the language / languages: English, German, Dutch, French, Italian, Polish, Spanish as an attachment in your email.

The manual is 0,88 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Homedics WFL-ROC-2 Manual

Product: