5
INSTRUCTIONS FOR USE :
The Shiatsu Massager comes with a screw located on the back of the unit to protect the massage
mechanism during shipment, which must be removed before the first use to allow the shiatsu
feature to function. Use the provided Allen key. Then, properly dispose of the screw.
Warning - Failure to remove screw may cause permanent damage to the massager.
NOTE: complete steps 1 to 3 before switching the appliance on at the mains.
1. Attach the Massage seat to almost any chair using the integrated strap located at the back of
the seat. Ensure it is held firmly in place by adjusting the strap as necessary.
2. Connect the power supply, plug the adaptor into a 230V AC mains outlet and switch on.
3. Once seated, use the remote control to operate the appliance. Press the button & select
the desired massage zone to start the massage.
4. Press the button to stop the massage.
NOTE:
• Only gentle force should be exerted against the seat in order to eliminate risk of injury.
• There is a 15 minute auto shut-off on this appliance for your safety. This feature should not be
considered as a substitute for ‘OFF’. Always remember to switch the appliance off when not
in use.
• Take care to position the product where it will not damage wooden or upholstered surfaces.
• The moving Shiatsu mechanism always “parks” or finishes in its lowest position. It will
continue to this position after the power has been turned off. If the electrical supply is
interrupted, when power is restored, the mechanism will “park” or move to its lowest position.
MAINTENANCE :
Cleaning
Unplug the appliance and allow to cool before cleaning. Clean only with a soft, slightly
damp sponge.
• Never allow water or any other liquids to come into contact with the appliance.
• Do not immerse in any liquid to clean.
• Never use abrasive cleaners, brushes, glass / furniture polish, paint thinner etc to clean.
Storage
Place the appliance in its box or in a safe, dry, cool place.
Avoid contact with sharp edges or pointed objects which might cut or puncture the fabric
surface. To avoid breakage, DO NOT wrap the power cord around the appliance. DO NOT hang
the unit by the cord.
Plug (MODEL SBM-210HA-2GB ONLY)
If the plug on this appliance is damaged, it can be
replaced with a BS 1363 plug, fitted with a 3A BS 1362
fuse. Only use a 3amp fuse with this appliance.
Care must be taken when changing the plug. If in doubt,
contact a qualified electrician.
GB
