791740
18
Zoom out
Zoom in
Previous page
1/114
Next page
18
4. HT8000 Controls and Functions
HT8000 PVR User Guide
Firmware Version 1.03.0A
4.3.1 Extending the Range of the RCU
Your HT8000 shipped with a small half-dome IR Sensor, on the end of a 2 metre
cable. This allows you to house the HT8000 inside a (well ventilated) cabinet,
without compromising on the unit’s responsiveness to remote commands.
If you don’t have clear line of sight to the front of the HT8000, or your TV cab-
inet has closed doors, you can connect the IR Sensor cable to the IR Sensor
jack on the back of the HT8000 (No. 15 in the diagram shown in section 4.2
Rear Panel, on page 15).
Position the IR Sensor where it is most sensitive to your remote commands
(usually, this is with the dome facing you) but obviously not too obtrusive in
the room. Avoid placing it near uncovered windows, or incandescent lights, as
these (infra-red light sources) can affect the sensor.
Use a small piece of double-sided tape (there should be one in the HT8000
box) to affix the sensor to a flat surface - if applicable.
4.3.2 Using the RCU to Control Your TV
The HT8000 RCU is capable of controlling hundreds of TV models - from a num-
ber of manufacturers.
To switch the RCU between TV Control mode and PVR Control mode:
1. Press the TV or STB button at the bottom of the remote control.
To check which RCU control mode is active:
Simply look at the TV / STB buttons, which light up whenever one of the other
remote control buttons is pressed.
In TV Control mode, the TV button will only illuminate when the button
pressed actually sends a remote signal to the TV.
As an example - when the RCU is in TV Control mode:
If the Volume + / - buttons are pressed, the TV button lights up.
Pressing the STOP button is not relevant to the TV so the TV button doesn’t
light up.
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Homecast HT8000 PVR at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Homecast HT8000 PVR in the language / languages: English as an attachment in your email.

The manual is 3.54 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info