623055
32
Zoom out
Zoom in
Previous page
1/148
Next page
4. Wheels, tyres
28
Changing the wheel
Set the corresponding jack* onto the axle pipe of the swinging
lever group or on the longitudinal beam in the area of the axle
attachmentsof the wheel to be changed.
In campers with a double axle, always position the car jack*
underneath the rear axle. We recommend using a hydraulic
jack*.
If the vehicle is parked on soft ground, lay a stable reinforce
ment under jack* (i.e., a board).
Lift the vehicle until the wheel is 2 or 3 cm o the ground.
Reposition the ratchet jack* handle if it should slant when you
jack up the vehicle.
Remove the wheel fastening screws and the wheel.
Attach the spare tyre to the hub and adjust it.
Reattach the wheel screws and tighten them lightly over the
transversal.
Lower the jack* and remove it.
Tighten the wheel fatening screws evenly with the wheel
wrench. The nominal value of the attachment torque is 110 nm
for steel rims and 120 nm for aluminium rims.
Release the handbrake and reactivate the stabilization system.
The rotating stanchions may not be used as a jack*!
After changing the tyre, the wheel screws must be
examined (after a 50 km drive) to ensure that they are
tight enough (tighten if necessary).
You should have a functional spare tyre available at all
times. Therefore, have the spare tyre replaced without
delay.
32


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hobby ONTOUR 2016 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hobby ONTOUR 2016 in the language / languages: English as an attachment in your email.

The manual is 16,52 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Hobby ONTOUR 2016

Hobby ONTOUR 2016 User Manual - German - 148 pages

Hobby ONTOUR 2016 User Manual - Dutch - 148 pages

Hobby ONTOUR 2016 User Manual - French - 137 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info