30144
9
Zoom out
Zoom in
Previous page
1/16
Next page
5. Receiver Servo Connections
EODFN#+0,#######
SRZHU#EDWWHU\#
(Not included)
7.2V
UHG#+.,#######
VWHHULQJ#VHUYR
\HOORZ#+.,########
Eoxh#+0,#######
.
0
PRWRU##########
ZLWK#314xi#
FDSDFLWRU####
Electric Car Installation
ESC
(Not included)
RECEIVER
CH1
CH2
VWHHULQJ#VHUYR
WKURWWOH#VHUYR#
(Not included)
Gas/Nitro Car Installation
RECEIVER
CH1
CH2
BATT
EDWWHU\#
4.8~6.0V
Note: Only one battery should be
connected at a time.
(Not included)
(Not included)
(Not included)
A) Receiver
- HFS-03MM Single Conversion
- You can use a separate receiver 4.8v - 6V battery pack if required for your particular model.
This battery is typically only used with a gas or nitro powered vehicles to supply power to the receiver.
Connect as shown.
- Note: If using an electronic speed control, it will supply the power to the receiver through the
connector plugged into channel #2.
- Be aware you should keep your receiver antenna at least 2" away from any power wires to
prevent potential interference.
- Route the antenna up an antenna tube as typically shown in your vehicles instructions.
- Warning: Be sure not to cut off any excess antenna wire, as it will shorten your operating range.
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hitec AGGRESSOR_SRX at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hitec AGGRESSOR_SRX in the language / languages: English as an attachment in your email.

The manual is 1,77 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info