571366

Hitachi UC12SC Manual

5
Zoom out
Zoom in
Previous page
1/18
Next page
3
English
CHARGING
Before using the power tool, charge the battery as follows.
1. Insert the battery in the charger.
Position the battery so that the nameplate faces
toward the HITACHI label of the charger and press
in the battery unit it comes into contact with the
bottom plate. (See Fig. 1 and Fig. 2)
2. Connect the charger power cord to the AC outlet.
Connecting the power cord will turn on the charger
(the pilot lamp lights up).
CAUTION
If the pilot lamp does not light up, pull out the
power cord from the AC outlet and check the
battery mounting condition.
3. The pilot lamp goes off when the battery is fully
charged.
⅜ Regarding recharging time
Table 1 shows the recharging time required according
to the type of battery.
Table 1 Type of battery and recharging time
(at temperature 20°C)
Type of battery Recharging time
EB12 Approx. 60 minutes
EB12G Approx. 90 minutes
EB12B Approx. 105 minutes
NOTE: The recharging time may vary according to the
ambient temperature and the power supply voltage
An example of the relationship between the input
power supply voltage and the charging time when
battery model EB12 is charged is shown in Fig. 3.
The charging time decreases if the ambient
temperature and input power supply voltage are
high and increases when they are low.
CAUTION
If the battery is heated due to direct sunlight,
etc., just after operation, the charger pilot lamp
may not light. At that time cool the battery first,
then start charging.
4. Disconnect the charger power cord from the AC
outlet.
5. Hold the charger tight and pull out the battery.
MAINTENANCE AND INSPECTION
1. Inspecting the mounting screws:
Regularly inspect all mounting screws and ensure
that they are properly tightened. Should any of the
screws be loose, retighten them immediately. Failure
to do so could result in serious hazard.
2. Cleaning of the charger
When the charger is stained, wipe with a soft dry
cloth or a cloth moistened with soapy water. Do not
use chloric solvents, gasoline or paint thinner, for
they melt plastics.
3. Store idle charger
When not in use, the charger should be stored in
dry, high or locked-up place — out of reach of
children.
NOTE
Due to HITACHI’s continuing program of research and
development, the specifications herein are subject to
change without prior notice.
IMPORTANT
Correct connecting of the plug
The wires of the mains lead are coloured in accordance
with the following code:
Blue: –Neutral
Brown: –Live
As the colours of the wires in the mains lead of this tool
may not correspond with the coloured markings
identifying the terminals in your plug proceed as follows:
The wire coloured blue must be connected to the terminal
marked with the letter N or coloured black.
The wire coloured brown must be connected to the
terminal marked with the letter L or coloured red. Neither
core must be connected to the earth terminal.
NOTE
This requirement is provided according to BRITISH
STANDARD 2769: 1984.
Therefore, the letter code and colour code may not be
applicable to other markets except United Kingdom.
100
90
80
70
60
50
40
30
20
10
0
10°C
20°C
(Minutes)
Charging time
Ambient temperature
95% of
Rated Voltage
Rated voltage
(Voltage Listed
on Nameplate)
105% of
Rated Voltage
Input Power Supply Voltage
Fig. 3 Relationship Between Input Power Supply Voltage
and Charging Time
Battery: EB12
… 5 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hitachi UC12SC at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hitachi UC12SC in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 0,22 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info