516064
21
Zoom out
Zoom in
Previous page
1/51
Next page
– 21 –
ENGLISH
MAINTENANCE
Cleaning and maintenance must be carried out when fi lter lamp lights. Before cleaning, stop
operation and switch off the power supply.
1. PRE-FILTER
Clean the pre-fi lter, as it removes dust inside the room. In case the pre-fi lter is full of dust, the air
ow will decrease and the cooling capacity will be reduced. Further, noise may occur. Be sure to
clean the pre-fi lters following the procedure below.
!
CAUTION
1
Open the front panel and remove the pre-fi lters
Gently lift and remove the air purifying fi lters
from the air purifying fi lter frame.
2
Vacuum dust from the pre-fi lters and air purifying
lters using vacuum cleaner. If there is too much
dust, rinse under running tap water and gently
brush it with soft bristle brush. Allow fi lters to
dry in shade.
3
Re-insert the air purifying fi lters to the fi lter
frame. Set the pre-fi lters with “FRONT” mark
facing front, and slot them into the original
state.
After attaching the pre-fi lters, push the front
panel at three arrow portions as shown in
gure and close it.
!
CAUTION
Do not wash with hot water at more than 40°C. The fi lters may shrink.
When washing it, shake off moisture completely and dry it in the shade; do not expose it directly
to the sun. The fi lters may shrink.
Do not use detergent on the air purifying fi lters as some detergent may deteriorate the fi lter
electrostatic performance.
NOTE:
Air purifying fi lters should be cleaned every month or sooner if noticeable loading occurs. When
used overtime, it may loose its deodorizing function. For maximum performance, it is recommended
to replace it every 1 year depending on application requirements.
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hitachi RAS-18LH1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hitachi RAS-18LH1 in the language / languages: English as an attachment in your email.

The manual is 0,8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info