635165
3
Zoom out
Zoom in
Previous page
1/6
Next page
CAUTIONS FOR OPERATION
When your refrigerator is first installed, wait 7 minutes for automatic system starting.
This refrigerator is not suitable for storing scientific data and medicines
Do not touch the evaporator because its temperature is very low.
When you place the heave appliances on “TABLE TOP” place the board on it to prevent it form being injured.
Do not place heavy appliances more than 40 kg.
Be careful not to stress the front overhang of “TABLE TOP”.
Do not place the heater, roaster, kettle and pot on the plastic “TABLE TOP” because their high temperature will deform it
(Temperature limit 60°C).
When using the heater, roaster and pot on “TABLE TOP” place the board on it to prevent it from being damaged by high
temperature.
Do not touch the back of the refrigerator and the mechanical parts at the back of the refrigerator, because their temperature is
high.
Handle the power cord carefully.
An impaired power cord will cause troubles such as fire of a short circuit.
Do not let the power cord touch the hot parts at the back of the refrigerator.
Do not wind or bundle the power cord. It will overheat.
When you pull out the power cord from the wall outlet, grasp the plug and pull straight forward. If you pull the cord, the cord
and plug will be impaired.
Wait more than five minutes to re-start the refrigerator after you stop it once.
(If you plug in the refrigerator immediately after you pull the plug, you may not be able to start the refrigerator)
INSTALLATION
Install refrigerator in convenience location away from extreme heat and cold.
The appliance must be positioned so that the plug is accessible.
This refrigerator is designed as a free-standing unit and cannot be built-in. Provide at least 30cm (12inhes) over top and 10cm
(4inches) at rear and 5cm (2inches) at both sides for proper air circulation. And provide clearances at side so door will open a
minimum of 90°.
Level refrigerator so it rests solidly on the floor without rocking. The leveling legs is located at right and front corner. Turn
clockwise to raise the corner, counter-clockwise to lower it.
Do not let the refrigerator back touch a sink because water splashes are liable to rust.
INITIAL OPERATION
Place all shelves, all kinds of vessels in their proper positions which have been removed for transportation.
Clean refrigerator and parts to remove dust incurred in shipping and packing. See “CLEANING” .
Store food after the temperature in the refrigerator gets sufficiently low.
It takes a few hours after starting the refrigerator to reach the proper temperature.
TEMPERATURE CONTROL
1.TEMPERATURE OF FREEZER COMPARTMENT
Set the dial to “NORMAL” for normal use. For most efficient use, adjust the dial according to freezer usage.
“COLD” For quick ice-making and food freezing.
“NORMAL” For normal use and for storing frozen food
for a long time.
“WARM” For storing ice cubes and save electricity.
“COLD” position will lower the inside temperature 2 or 3°C and
“WARM” position will raise the inside temperature 2 or 3 °C.
3
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hitachi R-240AT3 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hitachi R-240AT3 in the language / languages: English as an attachment in your email.

The manual is 0,21 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info