654259
7
Zoom out
Zoom in
Previous page
1/22
Next page
-7- -8-
4. Hold the main body by hand touching the side plate on either side. (Fig. 11)
Dirt on skin cannot be removed if the side plate of the main body is not touched by
hand.
Always hold the main body with your hand touching the side plate either on the
right or left side.
5. Lightly apply the cotton puff on skin and move it slowly.
Lightly apply it and slowly move as if sliding from the inside to the outside. (Fig. 12)
Use the product for 3 minutes at maximum.
An automatic stop is made when 3 minutes have elapsed after the switch is turned on.
If you still feel a tingling sensation after replenishing the toner, press the select
button and lower the level.
If the moisture in the cotton puff becomes insufficient or if it is hard to slide, replenish
the toner.
Do not use it on the same part of skin for more than 10 seconds.
If you feel a slight current stimulation (a tingling sensation) during use, replenish the
toner.
Do not touch the operation panel on the rear side during use.
(The switch may turn off or the potential level or vibration may change over.)
When the sound cannot be heard, this means automatic stop has been made.
6. An automatic stop is made when 3 minutes have elapsed after the switch is turned on.
7. Open the cover and remove the cotton puff. (Fig. 13)
Remove the cotton puff after use. Wipe away the toner attached to the main body
such as the head and the cover with tissue paper, etc.
Do not open the cover more than 90 degrees.
(Cause of detachment of the cover or breakage of the joint)
Avoid continuous use because it will strain the skin and cause skin trouble.
Dispose of the cotton puff once it is used, and do not use it again.
(Cause of skin trouble)
Always wipe away the toner attached to the main body.
(toner will get inside the main body and cause a malfunction.)
How to use with AC
1. Connect the charger to the main body and outlet.
2. Make sure to pull out the charger from the outlet and the main body.
Use according to "How to use."
The charge lamp stays out during operation.
How to attach the cover when it comes off.
Align the pins of the cover with the grooves in the main body, and push it in. (Fig. 14)
Fix the holes in the cover pins to the protrusions of the grooves.
CAUTION
Care for the main body
How to preserve
Wipe dirt on the main body with a cloth moistened with water and firmly squeezed.
Do not use alcohol, benzine, or thinner.
(Cause of deformation or discoloration)
Close the cover and preserve in an area with little humidity and dust.
Select the level suitable for your skin (at a level where you do not feel a tingling
sensation.)
The potential level and "vibration ON/OFF" immediately before an automatic stop or
turning "OFF" the power switch are stored in the memory.
Use at [1] is recommended for people who use this product for the first time and who
have sensitive skin or sense something wrong.
After use, take care of your skin with toner, milky lotion, etc., as usual.
Pin Hole GrooveProtrusion
Do not keep the cotton puff on one part of your skin but always
keep it in motion. (Cause of skin trouble or poor physical condition)
CAUTION
CAUTION
Never use this product in places splashed with water or in damp
places, such as in a bathroom.
(Cause of an electric shock or short circuit)
Do not wash the main body with water. And, do not soak in water
or splash water on it. (Cause of a failure)
Make sure to turn OFF the power switch. (Improperly turning on the
switch may cause irritation or a malfunction or short circuit.)
CAUTION
Do not leave this product in places splashed with water or in damp
places, such as in a bathroom. (Cause of a short circuit or failure)
Do not tie the cord of the charger, or wind the cord around
the charger.
(If the cord breaks, a short circuit or disconnection may occur.)
Do not leave this product in areas exposed to direct sunlight
(inside of a vehicle, etc.) or near heaters.
(Cause of deformation or discoloration)
CAUTION
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hitachi NC-5610 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hitachi NC-5610 in the language / languages: English as an attachment in your email.

The manual is 0,84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info