635245
9
Zoom out
Zoom in
Previous page
1/12
Next page
-8-
SERVICING AND REPAIRS
CAUTION: Be sure to disconnect the plug from the electrical outlet before
replacing the belt or the rotary brush.
*HOW TO REPLACE THE BELT (Fig. 21, 22)
The drive belt should be checked regularly to ensure that it is in good condition. If it is
stretched, cracked or cut, it should be replaced.
1. Turn the cleaner over. Release the handle to the middle position.
Remove the 3 screws from the belt cover. (Fig.21)
2. Remove the belt cover B as shown.
3. Lift the rotary brush assembly J out of the brush housing and remove the
worn or broken belt K.
*HOW TO REPLACE THE ROTARY BRUSH (Fig. 23, 24)
Be sure to disconnect plug from the electrical outlet. Remove the belt cover, the
belt, and the rotary brush assembly following the direction previously given.
1. Grasp the rubber end caps and turn them counterclockwise until one of the end
caps comes off as shown in Fig.23.
2. Separate the rotary brush from other parts.
3. Reassemble each part with new rotary brush as shown in Fig.24. Be careful
not to forget to install any parts.
4. Screw on the end caps and tighten.
5.
Replace the belt, the rotary brush and
the belt cover as described previously.
4. Place one end of the new belt over the motor shaft, and then slip the other end
around the pulley of the rotary brush. Reinstall the rotary brush back into
position.
Press firmly both sides of the rotary brush to be sure they are securely in place.
5. Place the four projections of the belt cover to the windows E provided on the
front end of the case and replace the belt cover, and re-fasten the screws
securely.
B
J
K
Fig.21
E
K
Fig.22
Fig.23 Fig.24
Trust washer
Rotary brush
End cap
Ball bearing
Bearing case
Shaft
Trust washer
Bearing case
Ball bearing
End cap
CV_90CY.p65 6/28/04, 3:23 PM9
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hitachi CV90CY at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hitachi CV90CY in the language / languages: English as an attachment in your email.

The manual is 0,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info