54279
19
Zoom out
Zoom in
Previous page
1/24
Next page
- 18 -
Other Features
TV Status
Programme Number, Programme Name (or AV) and
Sound Indicator are displayed on the upper left of the
screen. They are displayed after programme change
during 3 seconds.
Programme Number
Programme Name (4 characters)
These OSDs are displayed when a new programme is
entered by digit button, by pressing
or button,
or by TVbutton.
Double-digit (- -)
This OSD is displayed when the "Double-Digit" button
pressed in place of the programme number indicator.
After then, in order to enter a programme it must be
pressed to two digit consecutively. When it is late to
press any digit button this function will be ignored and
the display will be erased. In the same way it must not
be late to press any digit button after entering the first
digit. The limit of the delay time is 3 seconds.
Sound Indicator
This is a stereo option. The alternatives of the indicator
are Mono, Stereo, Dual-I and Dual-II. This indicator is
displayed under the programme number indicator on the
screen. "I-II" button is used to select Mono, Stereo,
Dual-I or Dual-II.
In Mono broadcast or in forced-mono (for stereo broad-
cast).
In Stereo broadcast.
If dual broadcast detected. Dual-I is selected in default
and also can be selected after Dual-II by Remote Con-
trol.
If Dual-II selected by Remote Control.
Picture Mode
The picture mode OSD is displayed below the sound
indicator, by TV Status OSDs. According to the WSS
data, inside of the OSD box 4:3 , 16:9, CINEMA,
SUBTITLE, ZOOM, PANORAMIC or AUTO is writ-
ten.
By pressing
(TXT_UPDATE) button (if Teletext is
not active) the picture mode can be switched into 4:3,
16:9, CINEMA, SUBTITLE, ZOOM, PANORAMIC
or AUTO Mode.
Mute Indicator
It is placed in the upper middle of the screen when en-
abled, and it stays there until it is disabled.
To cancel mute, there is two alternative; the first one is
pressing to "
" button, thus volume is set to the pre-
ceding value, and the second one is increasing the vol-
ume level, thus it starts at the minimum level to increase.
By decreasing the volume level in mute state, mute will
not be ignored, only the volume level will decrease. If
mute canceled after decreasing the volume level, the
volume will valid with the decreased level.
Volume Bar
It is displayed in the lower middle of the screen. When
a volume command is received (pressing
or
by Remote Control or Front panel) and no menu is ac-
tive, it stays on the screen for 3 seconds, after the last
volume command or until another command is received
in between.
AV Modes
By pressing the AVbutton you can switch your TV to
AV modes (except being in Teletext). Pressing this but-
ton will switch the TV in one of the optional AV modes:
EXT-1, RGB, EXT-2, F-AV or SVHS. EXT.1 supports
the RGB mode.
In order to quit the AV mode press the TV, digit but-
tons or 
 /  .
28-3217W-1244UK-ENG-ST7P-AK45-BSI-PLL-FS-RF-TILT-CLED-50047944.p65 13.07.2004, 11:2518
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hitachi C28WF560N at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hitachi C28WF560N in the language / languages: English as an attachment in your email.

The manual is 0,99 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info