543121
119
Zoom out
Zoom in
Previous page
1/122
Next page
119
Phenomenon Cases not involving a machine defect
Reference
page
Pen action is
unstable or pen
stops operating.
Is the power supply for the projector used at the
same time for other electrical products that require a
measurable amount of power?
Use a separate power supply for other electrical products
with a high power consumption.
14
Is dust accumulated on the two horns of the pen sensor?
Check the horns of the pen sensor, and remove any dust
accumulated on them using a vacuum cleaner.
107
The “StarBoard Software” les may be corrupted, or
installation may not have completed successfully.
Uninstall the “StarBoard Software” and reinstall it.
86
Has the battery run out?
Replace it with a new one.
19
Other than those above
Disconnect the power supply for the projector and connect
again.
Restart Windows
®
and “StarBoard Software”.
14
Lines cannot be
drawn properly
or are broken.
Has the battery run out?
Replace it with a new one.
19
Is dust accumulated on the two horns of the pen sensor?
Check the horns of the pen sensor, and remove any dust
accumulated on them using a vacuum cleaner.
107
Is the tip of the pen worn out?
Replace the tip of the pen with a new one.
19
The tip of the
pen does not
coincide with
the pen cursor.
Is calibration of the pen position correctly performed?
Perform calibration of the pen position.
For more details, refer to the manual for the “StarBoard
Software” in the bundled DVD-ROM.
Is the projector inclined?
Install the projector correctly and horizontally before
performing calibration of the pen position.
(continued on next page)
Phenomena that may be easy to be mistaken for machine defects (continued)
Troubleshooting
119


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hitachi BZ-1M at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hitachi BZ-1M in the language / languages: English as an attachment in your email.

The manual is 10,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info