48332
108
Zoom out
Zoom in
Previous page
1/120
Next page
108
TROUBLESHOOTING
Use the following checklist before assuming there is a problem with the system.
1. Are connections properly made?
2. Is the system being operated as explained in the operating instructions?
If the system does not seem to be operating properly, check as shown on the table below.
If none of these checks apply to the problem, the system may be malfunctioning.
Disconnect the power cord immediately and contact the store from which this unit was purchased.
English
Symptom
Cause Countermeasure
General
Tuner-amplifier
CD changer
Power cord is not plugged into a power
outlet.
VOLUME control is turned down.
Headphones are connected.
Speaker cords are not securely
connected.
Speaker polarities (e and d) are
inverted.
Function is not properly set.
Antenna direction is poor.
Signals from the broadcast station are
weak.
Noise from a TV or interference from a
broadcast station.
Signals on the power cord are being
modulated by the power source
frequency.
Disc is loaded upside-down.
Disc is dirty.
Disc is not of the specified type.
Disc is loaded upside-down.
Foreign object on disc tray.
Disc is dirty.
Disc is scratched.
Dirt, fingerprint, spittle, etc, on disc.
Disc is scratched.
Player is in an unstable place or a place
that vibrates strongly.
Signals on the power cord are being
modulated by the power source
frequency.
Unit does not turn on when
power operation switch is
pressed.
No sound is produced from
the speakers.
No treble sound is
produced, or the position of
the instruments is unclear.
A source other than the
desired one is heard.
Hissing sound is heard in
FM programs.
Hissing sound is heard in
MW programs.
Humming sound is heard in
MW programs.
Total numbers of tracks not
displayed when disc is
loaded.
Nothing happens when
operating buttons are
pressed.
Disc stops in the middle of
a track and will not play
properly.
Sound is broken.
Humming sound is heard
when disc is played.
Plug the power cord securely into an
outlet.
Set the control to an appropriate position.
Disconnect the headphones.
Connect securely.
Connect the speaker cords properly.
Set the desired function using the
FUNCTION button.
Change the direction of the antenna.
Install an outdoor antenna.
Turn the TV off.
Change the direction of the loop antenna.
Install an outdoor antenna.
Insert the power cord in the opposite
direction.
Install an outdoor antenna.
Reload the disc.
Clean the disc.
Replace with a disc of the specified
type.
Reload the disc.
Remove the disc and the foreign
object.
Clean the disc.
Replace with an unscratched disc.
Clean the disc.
Replace with an unscratched disc.
Place the player in a stable place with
no vibrations.
Insert the power cord in the opposite
direction.
INITIALIZATION OF THE MICROPROCESSOR
When the indication of the display is not correct or when the unit does not operate properly:
1. Unplug the AC cord.
2. Hold the STANDBY, MEMORY and BAND buttons for about 3 seconds and plug in the AC cord.
3. Release the 3 buttons, then switch on the unit.
108


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hitachi AXF300W at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hitachi AXF300W in the language / languages: English, German, Dutch, Danish, French, Italian, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 2,66 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info